Linux version 2.4.26 (root@spot) (gcc version 3.3.4) #3 Mon Jul 5 15:32:52 CEST 2004 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000d0000 - 00000000000d6000 (reserved) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000000f7f0000 (usable) BIOS-e820: 000000000f7f0000 - 000000000f7f8000 (ACPI data) BIOS-e820: 000000000f7f8000 - 000000000f800000 (ACPI NVS) BIOS-e820: 00000000fec00000 - 00000000fec01000 (reserved) BIOS-e820: 00000000fee00000 - 00000000fee01000 (reserved) BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved) 247MB LOWMEM available. On node 0 totalpages: 63472 zone(0): 4096 pages. zone(1): 59376 pages. zone(2): 0 pages. ACPI: RSDP (v000 AMI ) @ 0x000fa620 ACPI: RSDT (v001 AMIINT VIA_K7 0x00000010 MSFT 0x00000097) @ 0x0f7f0000 ACPI: FADT (v001 AMIINT VIA_K7 0x00000011 MSFT 0x00000097) @ 0x0f7f0030 ACPI: MADT (v001 AMIINT VIA_K7 0x00000009 MSFT 0x00000097) @ 0x0f7f00c0 ACPI: DSDT (v001 VIA K7VT4 0x00001000 MSFT 0x0100000d) @ 0x00000000 Kernel command line: BOOT_IMAGE=Linux.old ro root=900 pci=noacpi Initializing CPU#0 Detected 599.436 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 1196.03 BogoMIPS Memory: 248184k/253888k available (1668k kernel code, 5316k reserved, 578k data, 92k init, 0k highmem) Dentry cache hash table entries: 32768 (order: 6, 262144 bytes) Inode cache hash table entries: 16384 (order: 5, 131072 bytes) Mount cache hash table entries: 512 (order: 0, 4096 bytes) Buffer cache hash table entries: 16384 (order: 4, 65536 bytes) Page-cache hash table entries: 65536 (order: 6, 262144 bytes) CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line) CPU: L2 Cache: 64K (64 bytes/line) Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: After generic, caps: 0183fbff c1c7fbff 00000000 00000000 CPU: Common caps: 0183fbff c1c7fbff 00000000 00000000 CPU: AMD Duron(tm) stepping 00 Enabling fast FPU save and restore... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: Intel ACPI: Subsystem revision 20040326 PCI: PCI BIOS revision 2.10 entry at 0xfdae1, last bus=1 PCI: Using configuration type 1 ACPI: IRQ9 SCI: Edge set to Level Trigger. ACPI: Interpreter enabled ACPI: Using PIC for interrupt routing ACPI: System [ACPI] (supports S0 S1 S4 S5) ACPI: PCI Root Bridge [PCI0] (00:00) PCI: Probing PCI hardware (bus 00) ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT] ACPI: Power Resource [URP1] (off) ACPI: Power Resource [URP2] (off) ACPI: Power Resource [FDDP] (off) ACPI: Power Resource [LPTP] (off) ACPI: PCI Interrupt Link [LNKA] (IRQs 3 4 5 6 7 10 *11 12 14 15) ACPI: PCI Interrupt Link [LNKB] (IRQs 3 4 5 6 7 *10 11 12 14 15) ACPI: PCI Interrupt Link [LNKC] (IRQs 3 4 5 6 7 *10 11 12 14 15) ACPI: PCI Interrupt Link [LNKD] (IRQs 3 4 5 6 7 *10 11 12 14 15) PCI: Probing PCI hardware PCI: Using IRQ router default [1106/3177] at 00:11.0 PCI: Hardcoded IRQ 14 for device 00:11.1 Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Starting kswapd Journalled Block Device driver loaded Installing knfsd (copyright (C) 1996 okir@monad.swb.de). ACPI: Power Button (FF) [PWRF] ACPI: Sleep Button (CM) [SLPB] ACPI: Processor [CPU1] (supports C1) pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A Real Time Clock Driver v1.10f FDC 0 is a post-1991 82077 ne2k-pci.c:v1.02 10/19/2000 D. Becker/P. Gortmaker http://www.scyld.com/network/ne2k-pci.html eth0: RealTek RTL-8029 found at 0xe800, IRQ 10, 00:00:E8:5C:2D:AA. sis900.c: v1.08.06 9/24/2002 eth1: SiS 900 Internal MII PHY transceiver found at address 1. eth1: Using transceiver found at address 1 as default eth1: SiS 900 PCI Fast Ethernet at 0xec00, IRQ 10, 00:c0:ca:16:4c:b6. PPP generic driver version 2.4.2 PPP Deflate Compression module registered PPP BSD Compression module registered Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VP_IDE: IDE controller at PCI slot 00:11.1 PCI: Hardcoded IRQ 14 for device 00:11.1 VP_IDE: chipset revision 6 VP_IDE: not 100% native mode: will probe irqs later ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VP_IDE: VIA vt8235 (rev 00) IDE UDMA133 controller on pci00:11.1 ide0: BM-DMA at 0xfc00-0xfc07, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0xfc08-0xfc0f, BIOS settings: hdc:DMA, hdd:pio hda: WDC WD800BB-00CAA1, ATA DISK drive blk: queue c0371b40, I/O limit 4095Mb (mask 0xffffffff) hdc: ST380011A, ATA DISK drive blk: queue c0371f94, I/O limit 4095Mb (mask 0xffffffff) ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: attached ide-disk driver. hda: host protected area => 1 hda: 156301488 sectors (80026 MB) w/2048KiB Cache, CHS=9729/255/63, UDMA(100) hdc: attached ide-disk driver. hdc: host protected area => 1 hdc: 156301488 sectors (80026 MB) w/2048KiB Cache, CHS=9729/255/63, UDMA(100) Partition check: hda: hda1 hda2 hda3 hdc: hdc1 hdc2 hdc3 Via 686a/8233/8235 audio driver 1.9.1-ac3 via82cxxx: Six channel audio available PCI: Setting latency timer of device 00:11.5 to 64 ac97_codec: AC97 codec, id: CMI97 (CMedia) AC97 codec does not have proper volume support. via82cxxx: Codec rate locked at 48Khz via82cxxx: board #1 at 0xD800, IRQ 10 usb.c: registered new driver hub host/usb-uhci.c: $Revision: 1.275 $ time 15:33:03 Jul 5 2004 host/usb-uhci.c: High bandwidth mode enabled host/usb-uhci.c: USB UHCI at I/O 0xe400, IRQ 10 host/usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected host/usb-uhci.c: USB UHCI at I/O 0xe000, IRQ 10 host/usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 2 hub.c: USB hub found hub.c: 2 ports detected host/usb-uhci.c: USB UHCI at I/O 0xdc00, IRQ 11 host/usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 3 hub.c: USB hub found hub.c: 2 ports detected host/usb-uhci.c: v1.275:USB Universal Host Controller Interface driver i2c-core.o: i2c core module version 2.8.3 (20040115) i2c-dev.o: i2c /dev entries driver module version 2.8.3 (20040115) i2c-proc.o version 2.8.3 (20040115) md: raid1 personality registered as nr 3 md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27 md: Autodetecting RAID arrays. [events: 000005f4] [events: 000005f4] md: autorun ... md: considering hdc3 ... md: adding hdc3 ... md: adding hda3 ... md: created md0 md: bind md: bind md: running: md: hdc3's event counter: 000005f4 md: hda3's event counter: 000005f4 md: RAID level 1 does not need chunksize! Continuing anyway. md0: max total readahead window set to 124k md0: 1 data-disks, max readahead per data-disk: 124k raid1: device hdc3 operational as mirror 1 raid1: device hda3 operational as mirror 0 raid1: raid set md0 active with 2 out of 2 mirrors md: updating md0 RAID superblock on device md: hdc3 [events: 000005f5]<6>(write) hdc3's sb offset: 77858944 md: hda3 [events: 000005f5]<6>(write) hda3's sb offset: 77851776 md: ... autorun DONE. Initializing Cryptographic API NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 2048 buckets, 16Kbytes TCP: Hash tables configured (established 16384 bind 32768) ip_conntrack version 2.1 (1983 buckets, 15864 max) - 288 bytes per conntrack ip_tables: (C) 2000-2002 Netfilter core team NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Freeing unused kernel memory: 92k freed Adding Swap: 240964k swap-space (priority -1) Adding Swap: 249976k swap-space (priority -2) EXT3 FS 2.4-0.9.19, 19 August 2002 on md(9,0), internal journal i2c-viapro.o version 2.8.3 (20040115) i2c-dev.o: Registered 'SMBus Via Pro adapter at 0400' as minor 0 i2c-isa.o version 2.8.3 (20040115) i2c-dev.o: Registered 'ISA main adapter' as minor 1 w83627hf.o version 2.8.3 (20040115) via-rhine.c:v1.10-LK1.1.19 July-12-2003 Written by Donald Becker http://www.scyld.com/network/via-rhine.html eth2: VIA VT6102 Rhine-II at 0xd400, 00:0b:6a:2b:48:84, IRQ 11. eth2: MII PHY found at address 1, status 0x786d advertising 05e1 Link 45e1. kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,1), internal journal EXT3-fs: mounted filesystem with ordered data mode. eth2: Setting full-duplex based on MII #1 link partner capability of 45e1. eth1: Media Link On 100mbps half-duplex HTB init, kernel part version 3.16