Hello I have sata controller: 01:0b.0 RAID bus controller: CMD Technology Inc Silicon Image SiI 3112 SATARaid Controller (rev 02) Subsystem: CMD Technology Inc: Unknown device 6112 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- SERR- [disabled] [size=512K] Capabilities: [60] Power Management version 2 Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=2 PME- Kernel: 2.6.8.1-mm4 w/ libata config in attachment and this problem: [root@slack:~#] hdparm -Tt /dev/sda /dev/sda: Timing buffer-cache reads: 1392 MB in 2.00 seconds = 694.72 MB/sec BLKFLSBUF failed: Operation not supported HDIO_DRIVE_CMD(null) (wait for flush complete) failed: Operation not supported Timing buffered disk reads: 96 MB in 3.06 seconds = 31.40 MB/sec BLKFLSBUF failed: Operation not supported HDIO_DRIVE_CMD(null) (wait for flush complete) failed: Operation not supported [root@slack:~#] I have not this error on 2.6.8-rc4-mm1 (with the same config). Is this bug or new feature? -- . JID: rmrmg(at)jabberpl(dot)org | Wszystko jest trudne . mail: rmrmg(at)wp(dot)pl | przy odpowiednim . registered Linux user 261525 | stopniu abstrakcji _______ RMRMG signature version 0.0.5 ________