# dmesg firmware_features = 0x0 Starting Linux PPC64 2.6.7 ----------------------------------------------------- naca = 0xc000000000004000 naca->pftSize = 0x1b naca->debug_switch = 0x0 naca->interrupt_controller = 0x2 systemcfg = 0xc000000000005000 systemcfg->processorCount = 0x2 systemcfg->physicalMemorySize = 0x200000000 systemcfg->dCacheL1LineSize = 0x80 systemcfg->iCacheL1LineSize = 0x80 htab_data.htab = 0xc0000001f0000000 htab_data.num_ptegs = 0x100000 ----------------------------------------------------- [boot]0100 MM Init [boot]0100 MM Init Done idle = default_idle Linux version 2.6.7 (root@ppclinux) (gcc version 3.3.3 (Debian 20040401)) #3 SMP Wed Jul 21 11:57:40 UTC 2004 [boot]0012 Setup Arch NUMA associativity depth for CPU/Memory: 3 cpu 0 maps to domain 0 cpu 1 maps to domain 0 memory region 0 to 100000000 maps to domain 0 memory region 100000000 to 200000000 maps to domain 0 node 0 start_paddr = 0 end_paddr = 200000000 bootmap_pages = 40 bootmap_paddr = 1fefbf000 free_bootmem 0 200000000 reserve_bootmem 0 5a1308 reserve_bootmem 3fd01000 2ff000 reserve_bootmem 1f0000000 8000000 reserve_bootmem 1fefbf000 40000 reserve_bootmem 1fefff508 1000af8 No ramdisk, default root is /dev/sda2 Boot arguments: root=/dev/sdb1 ide0=noautotune EEH: PCI Enhanced I/O Error Handling Enabled PPC64 nvram contains 81920 bytes free_area_init node 0 200000 0 (hole: 0) On node 0 totalpages: 2097152 DMA zone: 2097152 pages, LIFO batch:16 Normal zone: 0 pages, LIFO batch:1 HighMem zone: 0 pages, LIFO batch:1 [boot]0015 Setup Done Built 1 zonelists Kernel command line: root=/dev/sdb1 ide0=noautotune ide_setup: ide0=noautotune [boot]0020 XICS Init [boot]0021 XICS Done PID hash table entries: 16 (order 4: 256 bytes) time_init: decrementer frequency = 181.495506 MHz time_init: processor frequency = 1452.000000 MHz Console: colour dummy device 80x25 freeing bootmem node 0 Memory: 8115904k available (0k kernel code, 0k data, 0k init) [c000000000000000,c000000200000000] Calibrating delay loop... 362.49 BogoMIPS Dentry cache hash table entries: 1048576 (order: 11, 8388608 bytes) Inode-cache hash table entries: 524288 (order: 10, 4194304 bytes) Mount-cache hash table entries: 256 (order: 0, 4096 bytes) Processor 1 found. Brought up 2 CPUs CPU0: online domain 0: span 00000001 groups: 00000001 domain 1: span 00000003 groups: 00000001 00000002 domain 2: span 00000003 groups: 00000003 CPU1: online domain 0: span 00000002 groups: 00000002 domain 1: span 00000003 groups: 00000002 00000001 domain 2: span 00000003 groups: 00000003 NET: Registered protocol family 16 PCI: Probing PCI hardware Using INTC for W82c105 IDE controller. IOMMU table initialized, virtual merging disabled ISA bridge at 0000:00:03.0 PCI: Probing PCI hardware done SCSI subsystem initialized matroxfb: Matrox G450 detected matroxfb: 640x480x8bpp (virtual: 640x26214) matroxfb: framebuffer at 0x3FDC0000000, mapped to 0xe000000080052000, size 16777216 fb0: MATROX frame buffer device fb0: initializing hardware Using unsupported 640x480 MTRX,G450 at e0000000, depth=8, pitch=640 fb1: Open Firmware frame buffer device on /pci@400000000111/pci@2/pci@1/display@0 RTAS daemon started Total HugeTLB memory allocated, 0 Initializing Cryptographic API Console: switching to colour frame buffer device 80x30 Using anticipatory io scheduler Floppy drive(s): fd0 is 2.88M FDC 0 is a National Semiconductor PC87306 loop: loaded (max 8 devices) netconsole: not configured, aborting Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx W82C105: IDE controller at PCI slot 0000:00:03.1 PCI: Enabling device: (0000:00:03.1), cmd 141 W82C105: chipset revision 5 W82C105: 100% native mode on irq 181 ide0: BM-DMA at 0xf040-0xf047, BIOS settings: hda:DMA, hdb:DMA ide1: BM-DMA at 0xf048-0xf04f, BIOS settings: hdc:DMA, hdd:DMA Probing IDE interface ide0... hda: IBM DROM00205, ATAPI CD/DVD-ROM drive hda: selected PIO 4 (120ns) (0240) hda: DMA enabled ide0 at 0xf000-0xf007,0xf012 on irq 181 Probing IDE interface ide1... Probing IDE interface ide1... hda: ATAPI 24X DVD-ROM drive, 256kB Cache, (U)DMA Uniform CD-ROM driver Revision: 3.20 ipr: IBM Power RAID SCSI Device Driver version: 2.0.7 (May 21, 2004) ipr 0000:41:01.0: Found IOA with IRQ: 183 ipr 0000:41:01.0: Starting IOA initialization sequence. ipr 0000:41:01.0: Adapter firmware version: 020A0018 ipr 0000:41:01.0: IOA initialized. scsi0 : IBM 570B Storage Adapter Vendor: HP Model: IBM-C568303030!D Rev: C209 Type: Sequential-Access ANSI SCSI revision: 02 Vendor: IBM Model: ST336607LC Rev: C50F Type: Direct-Access ANSI SCSI revision: 03 Vendor: IBM Model: ST336607LC Rev: C50F Type: Direct-Access ANSI SCSI revision: 03 Vendor: IBM Model: ST336607LC Rev: C50F Type: Direct-Access ANSI SCSI revision: 03 Vendor: IBM Model: VSBPD4E1 U4SCSI Rev: 2780 Type: Enclosure ANSI SCSI revision: 02 Vendor: IBM Model: ST336607LC Rev: C50F Type: Direct-Access ANSI SCSI revision: 03 Vendor: IBM Model: ST336607LC Rev: C50F Type: Direct-Access ANSI SCSI revision: 03 Vendor: IBM Model: VSBPD4E1 U4SCSI Rev: 2780 Type: Enclosure ANSI SCSI revision: 02 scsi: unknown device type 31 Vendor: IBM Model: 570B001 Rev: 0150 Type: Unknown ANSI SCSI revision: 00 st: Version 20040403, fixed bufsize 32768, s/g segs 256 Attached scsi tape st0 at scsi0, channel 0, id 0, lun 0 st0: try direct i/o: yes (alignment 512 B), max page reachable by HBA 2097152 SCSI device sda: 71096640 512-byte hdwr sectors (36401 MB) SCSI device sda: drive cache: write through sda: sda1 sda2 sda3 Attached scsi disk sda at scsi0, channel 0, id 4, lun 0 SCSI device sdb: 71096640 512-byte hdwr sectors (36401 MB) SCSI device sdb: drive cache: write through sdb: sdb1 Attached scsi disk sdb at scsi0, channel 0, id 5, lun 0 SCSI device sdc: 71096640 512-byte hdwr sectors (36401 MB) SCSI device sdc: drive cache: write through sdc: sdc1 < sdc5 > Attached scsi disk sdc at scsi0, channel 0, id 8, lun 0 SCSI device sdd: 71096640 512-byte hdwr sectors (36401 MB) SCSI device sdd: drive cache: write through sdd: unknown partition table Attached scsi disk sdd at scsi0, channel 1, id 5, lun 0 SCSI device sde: 71096640 512-byte hdwr sectors (36401 MB) SCSI device sde: drive cache: write through sde: unknown partition table Attached scsi disk sde at scsi0, channel 1, id 8, lun 0 Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 1 Attached scsi generic sg1 at scsi0, channel 0, id 4, lun 0, type 0 Attached scsi generic sg2 at scsi0, channel 0, id 5, lun 0, type 0 Attached scsi generic sg3 at scsi0, channel 0, id 8, lun 0, type 0 Attached scsi generic sg4 at scsi0, channel 0, id 15, lun 0, type 13 Attached scsi generic sg5 at scsi0, channel 1, id 5, lun 0, type 0 Attached scsi generic sg6 at scsi0, channel 1, id 8, lun 0, type 0 Attached scsi generic sg7 at scsi0, channel 1, id 15, lun 0, type 13 Attached scsi generic sg8 at scsi0, channel 255, id 255, lun 255, type 31 matroxfb_crtc2: secondary head of fb0 was registered as fb2 mice: PS/2 mouse device common for all mice serio: i8042 AUX port at 0x60,0x64 irq 12 atkbd.c: keyboard reset failed on isa0060/serio1 serio: i8042 KBD port at 0x60,0x64 irq 1 input: AT Raw Set 2 keyboard on isa0060/serio0 device-mapper: 4.1.0-ioctl (2003-12-10) initialised: dm@uk.sistina.com NET: Registered protocol family 2 IP: routing cache hash table of 32768 buckets, 512Kbytes TCP: Hash tables configured (established 1048576 bind 65536) IPv4 over IPv4 tunneling driver NET: Registered protocol family 1 NET: Registered protocol family 17 kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Freeing unused kernel memory: 384k freed Adding 2099192k swap on /dev/sda2. Priority:-1 extents:1 EXT3 FS on sdb1, internal journal e1000: Ignoring new-style parameters in presence of obsolete ones Intel(R) PRO/1000 Network Driver - version 5.2.52-k4 Copyright (c) 1999-2004 Intel Corporation. PCI: Enabling device: (0001:41:01.0), cmd 143 e1000: eth0: e1000_probe: Intel(R) PRO/1000 Network Connection kjournald starting. Commit interval 5 seconds EXT3 FS on sdc5, internal journal EXT3-fs: mounted filesystem with ordered data mode. e100: Intel(R) PRO/100 Network Driver, 3.0.18 e100: Copyright(c) 1999-2004 Intel Corporation PCI: Enabling device: (0000:21:01.0), cmd 143 e100: eth1: e100_probe: addr 0x3fd88030000, irq 182, MAC addr 00:09:6B:3E:3F:2A e1000: eth0: e1000_watchdog: NIC Link is Up 100 Mbps Full Duplex