Re: de2104x: interrupts before interrupt handler is registered

[Bjorn Helgaas <bjorn.helgaas@hp.com>]

On Tuesday 07 March 2006 07:21, linux-os (Dick Johnson) wrote:
> Thinking that a device powers ON in a stable state is naive. Many
> complex devices will have FPGA devices with floating pins that don't
> become stable until their contents are loaded serially. Others will
> have IRQ requests based upon power-on states that need to be cleared
> with a software reset. One can't issue a software reset until the
> device is enabled and enabling the device may generate interrupts
> with no handler in place so you have a "can't get there from here"
> problem.

Maybe you could handle this with a PCI quirk that runs before
pci_enable_device().  IIRC, we considered exposing a separate
interface for PCI IRQ allocation and routing, but decided it
wasn't worth the complexity since so few devices would need it.

> Linux-2.4.x had IRQs that were stable. One could put 
> a handler in place that would handle the possible burst of interrupts
> upon startup. Then this was changed so the IRQ value is wrong
> until an unrelated and illogical event occurs.

There are good reasons to wait to allocate the IRQ until you have
a driver that cares about the device.  I'm sorry that this broke
your specific case.

Bjorn