I am unable to get networking to work with 2.6.18-mm1 on my system. But 2.6.18 kernel on same system works fine. Here is some info about the system/debug attempts. Attached are the lspci output and config. Appreciate any help. Please let me know if you need more info. Suka System info: x326, 2 CPU (AMD Opteron Processor 250) Kernel info: $ uname -a Linux elm3b166 2.6.18-mm1 #4 SMP PREEMPT Tue Sep 26 18:11:58 PDT 2006 x86_64 GNU/Linux Config tokens differing between the 2.6.18 kernel that works and the 2.6.18-mm1 that does not are: Tokens in 2.6.18 but not in 2.6.18-mm1 config CONFIG_SCSI_FC_ATTRS=y CONFIG_SCSI_SATA_SIL=y CONFIG_SCSI_SATA=y Tokens in 2.6.18-mm1 but not in 2.6.18 config CONFIG_PROC_SYSCTL=y CONFIG_SATA_SIL=y CONFIG_ATA=y CONFIG_ARCH_POPULATES_NODE_MAP=y CONFIG_CRYPTO_ALGAPI=y CONFIG_MICROCODE_OLD_INTERFACE=y CONFIG_BLOCK=y CONFIG_VIDEO_V4L1_COMPAT=y CONFIG_ZONE_DMA=y CONFIG_FB_DDC=y All drivers compiled into kernel in both cases. Debug info: Checked hardware connections :-) (Rebooting on 2.6.18 kernel works - consistently) $ ethtool -i eth0 driver: e1000 version: 7.2.7-k2 firmware-version: N/A $ ip addr seems fine (up, broadcasting etc) $ ip -s link shows no errors/drops/overruns $ ip route shows the correct gw $ ethtool -S eth0 shows non-zero tx/rx packets/bytes but *rx_missed_errors* quite large (~138K) and increasing over time $ ping works fine $ ping no response. $ tcpdump -i eth0 host while pinging gateway, tcpdump shows messages like: 18:03:45.936161 arp who-has tell (Config file and lspci output are attached)