[PATCH] net: smc91x: Build fixes for general sh boards.

[Paul Mundt <lethal@linux-sh.org>]

SH boards in general only wire this up in 8 or 16-bit mode, and
as we never had the wrappers for 32-bit mode defined, SMC_CAN_USE_32BIT
caused build failure for the non-Solution Engine boards. This gets it
building again.

Also kill off the straggling set_irq_type() definition, this is left
over cruft that was missed when the rest of it switched to IRQ flags.

Signed-off-by: Paul Mundt <lethal@linux-sh.org>

--

 drivers/net/smc91x.h |    4 +---
 1 file changed, 1 insertion(+), 3 deletions(-)

diff --git a/drivers/net/smc91x.h b/drivers/net/smc91x.h
index f842944..6ff3a16 100644
--- a/drivers/net/smc91x.h
+++ b/drivers/net/smc91x.h
@@ -299,7 +299,7 @@ SMC_outw(u16 val, void __iomem *ioaddr, int reg)
 
 #define SMC_CAN_USE_8BIT       1
 #define SMC_CAN_USE_16BIT      1
-#define SMC_CAN_USE_32BIT      1
+#define SMC_CAN_USE_32BIT      0
 
 #define SMC_inb(a, r)          inb((a) + (r))
 #define SMC_inw(a, r)          inw((a) + (r))
@@ -310,8 +310,6 @@ SMC_outw(u16 val, void __iomem *ioaddr, int reg)
 
 #endif  /* BOARDS */
 
-#define set_irq_type(irq, type) do {} while (0)
-
 #elif   defined(CONFIG_M32R)
 
 #define SMC_CAN_USE_8BIT	0