Re: Partition check considered as error is breaking mounting in 2.6.27

[Herton Ronaldo Krzesinski <herton@mandriva.com.br>]

On Friday 12 September 2008 17:14:04 Herton Ronaldo Krzesinski wrote:
> On Friday 12 September 2008 15:40:41 Alan Stern wrote:
> > On Fri, 12 Sep 2008, Herton Ronaldo Krzesinski wrote:
> > > > > After formatting the camera is this you get from fdisk (display units
> > > > > in sectors):
> > > > >
> > > > > Disk /dev/sdb: 21 MB, 21544448 bytes
> > > > > 6 heads, 16 sectors/track, 438 cylinders, total 42079 sectors
> > > > > Units = sectors of 1 * 512 = 512 bytes
> > > > > Disk identifier: 0x00000000
> > > > >
> > > > >    Device Boot      Start         End      Blocks   Id  System
> > > > > /dev/sdb1   *           1       42079       21039+   1  FAT12
> > > > > Partition 1 has different physical/logical endings:
> > > > >      phys=(328, 5, 16) logical=(438, 1, 16)
> > > > >
> > > > > (after zeroing out the partition table I only run fdisk on the
> > > > > device, created the a new partition with maximum size allowed and
> > > > > change the type to FAT12)
> > > >
> > > > That is not a valid procedure.  You have to go into Expert mode and set
> > > > the number of sectors, heads, and tracks first.  Most likely you'll
> > > > want to set them to the same values used by the firmware; it looks like
> > > > the firmware thinks there are 16 sectors/track, 8 heads, and 329
> > > > tracks.
> > >
> > > 8 heads? it reports 6 from the fdisk output:
> > > phys=(328, 5, 16) logical=(438, 1, 16)
> >
> > No.  phys=(328, 5, 16) doesn't mean that the device has 329 tracks, 6
> > heads, and 16 sectors.  It means that the last sector of the partition
> > (as recorded in the table) is track 328, head 5, sector 16.
> > Note that partitions don't have to end on cylinder boundaries.
> >
> > Guessing that the firmware intends there to be 16 sectors per track,
> > and also guessing that the 42079 value is too low by one, we get a
> > total of 42080 / 16 = 2630 as the product of heads and tracks.  Since
> > 2630 = 8 * 328.75 this seems to say that the firmware thinks there are
> > approximately 329 tracks and 8 heads.  That explains the "328" above.
> >
> > Continuing this reasoning, the physical end (328,5,16) corresponds to
> > sector (328*8*16) + (5*16) + 15 = 42079 (the 15 is because sector
> > numbers start at 1 instead of at 0).  Which would be valid if the first
> > sector of the partition was sector 1, or phys=(0,0,2), and if the
> > capacity was 42080.  However you didn't tell us what value was stored
> > in the table for the start of the partition.
> 
> Ok, thanks for the explanation, indeed you are right, it's about the physical 
> end, I confused things, I'm not used to CHS... The start sector is 1, 
> (0,0,2), so what you said is valid. I attach the dump of first sector of the 
> memory here just for reference that shows this.
> 
> >
> > > > Adding quirks to alter partition sizes sounds very dangerous.  Your
> > > > best bet is simply to write a valid partition table.
> > >
> > > Yes, but this is breaking other devices, not only this olympus camera.
> > > Bogdano reported what could be the same case with his cel. phone (Bogdano
> > > can you give more details?), also on IRC today Damien Lallement
> > > complained about what looks the same issue of "p* exceeds device
> > > capacity" (Damien can you give more info too?). But I'm afraid of how
> > > much devices this partition error fatal check now can affect, after all
> > > it's not "user friendly" to instruct the user to use hexedit or fdisk to
> > > fix the device's partitions.
> >
> > You should complain to the people who wrote and accepted the
> > troublesome commit.  Tell them it caused a regression; that always gets
> > people's attention!
> 
> Ok, here goes a patch that revert the relevant part of the commit and 
> goes back to behaviour of previous kernels, and fixes the regression here.
> If considered a good solution, can be applied.
> 
> ---
> 
> fs/partition/check.c: revert part of commit 04ebd4aee52b06a2c38127d9208546e5b96f3a19
> 
> Fix regression introduced by commit 04ebd4aee52b06a2c38127d9208546e5b96f3a19,
> where kernel changed behaviour making fatal the error when some partition
> exceeds the limit of the device size. Some buggy devices become inacessible
> because of errors in their partition table if the error is fatal.
> 
> This closes http://bugzilla.kernel.org/show_bug.cgi?id=11554

And I forgot my Signed-off....

Signed-off-by: Herton Ronaldo Krzesinski <herton@mandriva.com.br>

> 
> diff --git a/fs/partitions/check.c b/fs/partitions/check.c
> index 7d6b34e..15c70df 100644
> --- a/fs/partitions/check.c
> +++ b/fs/partitions/check.c
> @@ -499,9 +499,9 @@ int rescan_partitions(struct gendisk *disk, struct block_device *bdev)
>  		if (!size)
>  			continue;
>  		if (from + size > get_capacity(disk)) {
> -			printk(KERN_ERR " %s: p%d exceeds device capacity\n",
> +			printk(KERN_WARNING
> +				" %s: p%d exceeds device capacity\n",
>  				disk->disk_name, p);
> -			continue;
>  		}
>  		res = add_partition(disk, p, from, size, state->parts[p].flags);
>  		if (res) {
> 
> 
> >
> > Alan Stern
> 

--
[]'s
Herton