Re: changing module from single to multi-file build

[Sam Ravnborg <sam@ravnborg.org>]

On Tue, Oct 13, 2009 at 09:24:27AM +0100, Ben Dooks wrote:
> I have a driver, drivers/spi/spi_s3c24xx.c in this case that I have
> written an FIQ handler for which requires some assembly code. My attempts
> at trying to change it so that I can build a single module with both the
> C and ASM code linked together have not yet been a success.
> 
> The original makefile bit from drivers/spi/Makefile was:
> 
>  obj-$(CONFIG_SPI_S3C24XX)              += spi_s3c24xx.o
> 
> This allows it to work as a kernel builtin:
> 
>  obj-$(CONFIG_SPI_S3C24XX)              += spi_s3c24xx.o
>  obj-$(CONFIG_SPI_S3C24XX_FIQ)          += spi_s3c24xx_fiq.o
> 
> I tried adding the following to the file, but this does not make
> the FIQ code, I assume as there is still drivers/spi/spi_s3c24xx.c.
> 
>  obj-spi_s3c24xx-y                      := spi_s3c24xx.o
>  obj-spi_s3c24xx-$(CONFIG_SPI_S3C24XX_FIQ) += spi_s3c24xx_fiq.o

A multi-file module cannot have a .c file with a name
equal to the modulename.
So going from a single-file module to a multi-file
module rwquire you to rename the .c file if you want
to keep the old module name.

	Sam