Re: [PATCH] platform/x86/intel/pmc: Use each PMC's own status map on S0ix failure

["Ilpo Järvinen" <ilpo.jarvinen@linux.intel.com>]

On Sun, 18 Oct 2026, Cole Leavitt wrote:

> When S0ix entry fails and warn_on_s0ix_failures is set,
> pmc_core_resume_common() dumps the latched LPM status registers of every
> PMC.  The loop over pmcdev->pmcs[] however passes the register offset and

One space is enough.

> bit maps of the main PMC to pmc_core_lpm_display() for all of them, so
> the registers of the secondary PMCs are read at the main PMC's offset
> and decoded with the main PMC's bit names.  On platforms with more than
> one PMC, such as Arrow Lake-HX with an 800 series PCH, the dump
> attributes the PCH's power gating state to the wrong IP blocks, which
> makes it useless for finding the device that blocks S0ix.
> 
> Use the status offset and maps of the PMC being displayed.
> 
> Fixes: 2bcef4529222 ("platform/x86:intel/pmc: Enable debugfs multiple PMC support")
> Signed-off-by: Cole Leavitt <cole@unwrap.rs>
> ---
> 
> Notes:
>     Tested on a Lenovo ThinkPad P16 Gen 3 (Core Ultra 9 275HX, JHL9580
>     Barlow Ridge host, I226 Ethernet), in daily use since 2026-09-17.
> 
>  drivers/platform/x86/intel/pmc/core.c | 6 +++---
>  1 file changed, 3 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/platform/x86/intel/pmc/core.c b/drivers/platform/x86/intel/pmc/core.c
> index 9f77c0716e59..3fd72e6a08ce 100644
> --- a/drivers/platform/x86/intel/pmc/core.c
> +++ b/drivers/platform/x86/intel/pmc/core.c
> @@ -2068,8 +2068,6 @@ int pmc_core_resume_common(struct pmc_dev *pmcdev)
>  {
>  	struct device *dev = &pmcdev->pdev->dev;
>  	struct pmc *pmc = pmcdev->pmcs[PMC_IDX_MAIN];
> -	const struct pmc_bit_map **maps = pmc->map->lpm_sts;
> -	int offset = pmc->map->lpm_status_offset;
>  	unsigned int pmc_idx, i;
>  
>  	/* Check if the syspend used S0ix */
> @@ -2114,7 +2112,9 @@ int pmc_core_resume_common(struct pmc_dev *pmcdev)
>  		if (!pmc)
>  			continue;
>  		if (pmc->map->lpm_sts)
> -			pmc_core_lpm_display(pmc, dev, NULL, offset, pmc_idx, "STATUS", maps);
> +			pmc_core_lpm_display(pmc, dev, NULL,
> +					     pmc->map->lpm_status_offset,
> +					     pmc_idx, "STATUS", pmc->map->lpm_sts);

This looks good finding but I suggest you use intermediate variables 
similar to what the other callers of pmc_core_lpm_display() do. It would 
also allow converting that if check to use the same local var.

-- 
 i.