From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1752705Ab1AFKai (ORCPT ); Thu, 6 Jan 2011 05:30:38 -0500 Received: from rhlx01.hs-esslingen.de ([129.143.116.10]:55661 "EHLO rhlx01.hs-esslingen.de" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1752427Ab1AFKah (ORCPT ); Thu, 6 Jan 2011 05:30:37 -0500 Date: Thu, 6 Jan 2011 11:30:35 +0100 From: Andreas Mohr To: Robert Hancock Cc: sclark46@earthlink.net, linux-kernel , ide Subject: Re: Kernel 2.6.37 erroneously limiting to UDMA/33 Message-ID: <20110106103035.GA3484@rhlx01.hs-esslingen.de> MIME-Version: 1.0 Content-Type: text/plain; charset=us-ascii Content-Disposition: inline In-Reply-To: <4D2503B1.4080500@gmail.com> X-Priority: none User-Agent: Mutt/1.5.20 (2009-08-17) Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Hi, Robert Hancock wrote: > On 01/05/2011 12:33 PM, Stephen Clark wrote: > > Hello, > > > > Why is the kernel limiting me to udma/33 when the device says it can do > > ata2.01: CFA: TRANSCEND, 20070831, max UDMA/66 > > > > There is no cable the compact flash is a socket on the motherboard! > > The kernel has no way to know that, and presumably the board isn't > connecting the signal for IDE pin 34 to ground in order to properly > signal that an 80-wire cable (or equivalent) is connected so that speeds > over UDMA33 can be used. > > You should be able to use the libata.force=80c option on the kernel > command line to override the cable detection. Further comments for the OP: If 80c happens to be correct for this machine (since it's soldered it's quite obvious) and the machine is quite wide-spread, perhaps one needs to add overrides within drivers/ata/pata_via.c/via_cable_detect() functionality, analogous to the ata_piix.c/ich_pata_cable_detect() case where it uses an entire ich_laptop device list to match against, to detect special 80c compatible cases. But since pata_via.c has the insightful comment "Perform cable detection. Actually for the VIA case the BIOS already did this for us." it looks like your BIOS might be considered "broken" due to not indicating 80c for such a solder job --> BIOS upgrade available? And perhaps better avoid mentioning a specific kernel in the subject line unless it's a regression (which likely isn't the case here), or write it like "..... (on 2.6.XXX)". Andreas Mohr