Re: [PATCH 1/3] tty: serial: Use hub6_serial_X when CONFIG_SERIAL_8250_HUB6 is defined

[Alan Cox <alan@lxorguk.ukuu.org.uk>]

Most of these are not needed

> +#if CONFIG_SERIAL_8250_HUB6
>  static unsigned int hub6_serial_in(struct uart_port *p, int offset)
>  {
>  	offset = map_8250_in_reg(p, offset) << p->regshift;
> @@ -400,6 +401,7 @@ static void hub6_serial_out(struct uart_port *p, int offset, int value)
>  	outb(p->hub6 - 1 + offset, p->iobase);
>  	outb(value, p->iobase + 1);
>  }
> +#endif

This one is needed 
>  
>  static unsigned int mem_serial_in(struct uart_port *p, int offset)
>  {
> @@ -508,10 +510,12 @@ static void set_io_from_upio(struct uart_port *p)
>  	struct uart_8250_port *up =
>  		container_of(p, struct uart_8250_port, port);
>  	switch (p->iotype) {
> +#if CONFIG_SERIAL_8250_HUB6
>  	case UPIO_HUB6:
>  		p->serial_in = hub6_serial_in;
>  		p->serial_out = hub6_serial_out;
>  		break;
> +#endif

And this - but not the rest.

It is also such a miniscule amount of code it seems like it does not
justify the complexity of being configurable this way.