Re: [PATCH 3/5] usb: musb: ux500: add otg notifier support

[Felipe Balbi <balbi@ti.com>]

[-- Attachment #1: Type: text/plain, Size: 1474 bytes --]

On Thu, Feb 28, 2013 at 11:38:52AM +0100, Fabio Baltieri wrote:
> Add transceiver notifier event handling to the ux500 driver to set vbus
> on specific transceiver events.
> 
> Acked-by: Linus Walleij <linus.walleij@linaro.org>
> Signed-off-by: Fabio Baltieri <fabio.baltieri@linaro.org>
> ---
>  drivers/usb/musb/ux500.c | 41 +++++++++++++++++++++++++++++++++++++++++
>  1 file changed, 41 insertions(+)
> 
> diff --git a/drivers/usb/musb/ux500.c b/drivers/usb/musb/ux500.c
> index 5b742ba..b20326bb 100644
> --- a/drivers/usb/musb/ux500.c
> +++ b/drivers/usb/musb/ux500.c
> @@ -98,6 +98,36 @@ static void ux500_musb_set_vbus(struct musb *musb, int is_on)
>  		musb_readb(musb->mregs, MUSB_DEVCTL));
>  }
>  
> +static int musb_otg_notifications(struct notifier_block *nb,
> +		unsigned long event, void *unused)
> +{
> +	struct musb *musb = container_of(nb, struct musb, nb);
> +
> +	dev_dbg(musb->controller, "musb_otg_notifications %ld %s\n",
> +			event, otg_state_string(musb->xceiv->state));
> +
> +	switch (event) {
> +	case USB_EVENT_ID:
> +		dev_dbg(musb->controller, "ID GND\n");
> +		ux500_musb_set_vbus(musb, 1);
> +		break;
> +	case USB_EVENT_VBUS:
> +		dev_dbg(musb->controller, "VBUS Connect\n");

are you sure this is correct ? you're not doing anything in case of
vbus event. Shouldn't you make sure your vbus is off ? What if your user
uses a non-standard cable which has id-pin grounded on both sides ?

-- 
balbi

[-- Attachment #2: Digital signature --]
[-- Type: application/pgp-signature, Size: 836 bytes --]