Re: [PATCH v2 1/2] clk: qcom: Add support for RPM Clocks

[Bjorn Andersson <bjorn.andersson@sonymobile.com>]

On Thu 03 Sep 08:40 PDT 2015, Georgi Djakov wrote:

> Hi Stephen,
> 
> On 09/02/2015 11:31 PM, Stephen Boyd wrote:
> > On 08/03, Georgi Djakov wrote:
> >> diff --git a/drivers/clk/qcom/clk-smd-rpm.c b/drivers/clk/qcom/clk-smd-rpm.c
> >> new file mode 100644
> >> index 000000000000..e564673ec3a5
> >> --- /dev/null
> >> +++ b/drivers/clk/qcom/clk-smd-rpm.c
> 
> [..]
> 
> >> +static int clk_smd_rpm_set_rate(struct clk_hw *hw, unsigned long rate,
> >> +				unsigned long parent_rate)
> >> +{
> >> +	struct clk_smd_rpm *r = to_clk_smd_rpm(hw);
> >> +	int ret = 0;
> >> +
> >> +	if (r->enabled) {
> >> +		u32 value;
> >> +		struct clk_smd_rpm *peer = r->peer;
> >> +
> >> +		/* Take peer clock's rate into account only if it's enabled. */
> >> +		if (peer->enabled)
> > 
> > This peer stuff almost doesn't even matter because we're only
> > sending active set requests. Why can't this code be updated to
> > send both active and sleep set requests? The sleep set stuff
> > won't be cached, etc., but I don't see a problem in doing both.
> > Otherwise we should drop all the peer stuff until we introduce
> > active only clocks.
> 
> Initially I tried sending both active and sleep sets, but as they are
> not cached like in downstream (yet) i got hangs during boot. Disabling
> caching in downstream kernel also caused the same hangs, so i left
> this out for now. Will try debugging it further.
> 

This sounds odd, although I presume the downstream code is rarely/never
tested with the caching disabled.

Can you please retry this with [1] applied (should be in -next), the RPM
fifo is tiny, so I would not be surprised if this could be your problem.

[1] https://lkml.org/lkml/2015/8/24/756

Regards,
Bjorn