mirror of https://lore.kernel.org/lkml/
 help / color / mirror / Atom feed
From: Wim Van Sebroeck <wim@iguana.be>
To: Tim Harvey <tharvey@gateworks.com>
Cc: Guenter Roeck <linux@roeck-us.net>,
	linux-watchdog@vger.kernel.org, Rob Herring <robh+dt@kernel.org>,
	Pawel Moll <pawel.moll@arm.com>,
	Mark Rutland <mark.rutland@arm.com>,
	Ian Campbell <ijc+devicetree@hellion.org.uk>,
	Kumar Gala <galak@codeaurora.org>,
	"devicetree@vger.kernel.org" <devicetree@vger.kernel.org>,
	"linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>,
	Shawn Guo <shawnguo@kernel.org>,
	Sascha Hauer <kernel@pengutronix.de>,
	Russell King - ARM Linux <linux@arm.linux.org.uk>,
	"linux-arm-kernel@lists.infradead.org" 
	<linux-arm-kernel@lists.infradead.org>,
	justin.waters@timesys.com, Lucas Stach <l.stach@pengutronix.de>,
	Fabio Estevam <festevam@gmail.com>, Stefan Roese <sr@denx.de>,
	Akshay Bhat <akshay.bhat@timesys.com>
Subject: Re: [PATCH v4 1/2] watchdog: imx2_wdt: add external reset support via 'ext-reset-output' dt prop
Date: Mon, 28 Dec 2015 17:29:23 +0100	[thread overview]
Message-ID: <20151228162923.GA31680@spo001.leaseweb.nl> (raw)
In-Reply-To: <CAJ+vNU2qHQPSJ1KWp_3f3vAdeuOcF0ooZHmHsdafabZLXJv=Bw@mail.gmail.com>

Hi Tim,

> On Wed, Dec 2, 2015 at 12:54 PM, Tim Harvey <tharvey@gateworks.com> wrote:
> >
> > On Wed, Dec 2, 2015 at 11:11 AM, Akshay Bhat <akshay.bhat@timesys.com> wrote:
> > >
> > >
> > > On 11/06/2015 05:02 PM, Guenter Roeck wrote:
> > >>
> > >> On Fri, Nov 06, 2015 at 11:53:42AM -0800, Tim Harvey wrote:
> > >>>
> > >>> On Thu, Nov 5, 2015 at 2:23 PM, Guenter Roeck <linux@roeck-us.net> wrote:
> > >>>>
> > >>>> On Thu, Nov 05, 2015 at 04:19:21PM -0500, Akshay Bhat wrote:
> > >>>>>
> > >>>>> From: Tim Harvey <tharvey@gateworks.com>
> > >>>>>
> > >>>>> The IMX6 watchdog supports assertion of a signal (WDOG_B) which
> > >>>>> can be pinmux'd to an external pin. This is typically used for boards
> > >>>>> that
> > >>>>> have PMIC's in control of the IMX6 power rails. In fact, failure to use
> > >>>>> such an external reset on boards with external PMIC's can result in
> > >>>>> various
> > >>>>> hangs due to the IMX6 not being fully reset [1] as well as the board
> > >>>>> failing
> > >>>>> to reset because its PMIC has not been reset to provide adequate
> > >>>>> voltage for
> > >>>>> the CPU when coming out of reset at 800Mhz.
> > >>>>>
> > >>>>> This uses a new device-tree property 'ext-reset-output' to indicate the
> > >>>>> board has such a reset and to cause the watchdog to be configured to
> > >>>>> assert
> > >>>>> WDOG_B instead of an internal reset both on a watchdog timeout and in
> > >>>>> system_restart.
> > >>>>>
> > >>>>> [1]
> > >>>>> http://lists.infradead.org/pipermail/linux-arm-kernel/2015-March/333689.html
> > >>>>>
> > >>>>> Cc: Lucas Stach <l.stach@pengutronix.de>
> > >>>>> Signed-off-by: Tim Harvey <tharvey@gateworks.com>
> > >>>>> ---
> > >>>>>   .../devicetree/bindings/watchdog/fsl-imx-wdt.txt     |  2 ++
> > >>>>>   drivers/watchdog/imx2_wdt.c                          | 20
> > >>>>> ++++++++++++++++++--
> > >>>>>   2 files changed, 20 insertions(+), 2 deletions(-)
> > >>>>>
> > >>>>> diff --git a/Documentation/devicetree/bindings/watchdog/fsl-imx-wdt.txt
> > >>>>> b/Documentation/devicetree/bindings/watchdog/fsl-imx-wdt.txt
> > >>>>> index 8dab6fd..9b89b3a 100644
> > >>>>> --- a/Documentation/devicetree/bindings/watchdog/fsl-imx-wdt.txt
> > >>>>> +++ b/Documentation/devicetree/bindings/watchdog/fsl-imx-wdt.txt
> > >>>>> @@ -9,6 +9,8 @@ Optional property:
> > >>>>
> > >>>>
> > >>>> properties ?
> > >>>>
> > >>>>>   - big-endian: If present the watchdog device's registers are
> > >>>>> implemented
> > >>>>>     in big endian mode, otherwise in native mode(same with CPU), for
> > >>>>> more
> > >>>>>     detail please see:
> > >>>>> Documentation/devicetree/bindings/regmap/regmap.txt.
> > >>>>> +- ext-reset-output: If present the watchdog device is configured to
> > >>>>> assert its
> > >>>>
> > >>>>
> > >>>> Should that have a vendor prefix ? Also, not sure if "-output"
> > >>>> has any real value in the property name. "fsl,external-reset", maybe ?
> > >>>
> > >>>
> > >>> Hi Guenter,
> > >>>
> > >>> I don't see why a vendor prefix is necessary - its a feature of the
> > >>> IMX6 watchdog supported by this driver to be able to trigger an
> > >>> internal chip-level reset and/or an external signal that can be hooked
> > >>> to additional hardware.
> > >>>
> > >> Sounded like vendor specific to me, but then I am not a devicetree
> > >> maintainer,
> > >> so I am not an authority on the subject.
> > >
> > >
> > > Devicetree maintainers,
> > >
> > > Any thoughts?
> > >
> > > Tim,
> > >
> > > After looking at all the other watchdog drivers, it does not appear that
> > > there is any other processor which uses a similar feature. Since imx is the
> > > only processor that appears to support this feature, it might make sense in
> > > making this vendor specific. If in the future it is found more processors
> > > support a similar functionality, it can be revisited and moved out from
> > > being vendor specific?
> > >
> >
> > I'm certainly no expert on device-tree policy. I understand your
> > point, but realize that the driver in question is imx2_wdt.c
> > (compatible = "fsl,imx21-wdt"). This is an IP block inside the silicon
> > of only Freescale chips, so its not like a future omap chip would be
> > using this driver - only fsl devices. So why would it need a 'vendor'
> > property any more than its other properties?
> >
> > Regards,
> >
> > Tim
> 
> Wim,
> 
> Does the lack of response mean overwhelming approval?
> 
> I haven't heard any valid complaints - what does it take to get this approved?
> 
> Regards,
> 
> Tim

I have no objections against the idea and the code itself.
But as Guenter pointed out: it would be handy to get feedback from the devicetree maintainers on the above discussion.

Kind regards,
Wim.


  parent reply	other threads:[~2015-12-28 16:29 UTC|newest]

Thread overview: 19+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2015-11-05 21:19 [PATCH v4 0/2] imx6: Implement external watchdog reset Akshay Bhat
2015-11-05 21:19 ` [PATCH v4 1/2] watchdog: imx2_wdt: add external reset support via 'ext-reset-output' dt prop Akshay Bhat
2015-11-05 22:23   ` Guenter Roeck
2015-11-06 19:53     ` Tim Harvey
2015-11-06 22:02       ` Guenter Roeck
2015-12-02 19:11         ` Akshay Bhat
2015-12-02 20:54           ` Tim Harvey
2015-12-17 15:02             ` Tim Harvey
2015-12-17 15:32               ` Guenter Roeck
2015-12-28 16:29               ` Wim Van Sebroeck [this message]
2016-01-28 20:28                 ` Akshay Bhat
2016-02-28 13:56                   ` Fabio Estevam
2016-03-28 20:19                     ` Akshay Bhat
2016-03-30  1:22                       ` Shawn Guo
2016-03-30 21:09                         ` Guenter Roeck
2016-03-31  1:57                           ` Shawn Guo
2016-03-31 18:01                             ` Tim Harvey
2016-04-01  1:39                               ` Shawn Guo
2015-11-05 21:19 ` [PATCH v4 2/2] ARM: dts: ventana: Add ext-reset support Akshay Bhat

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20151228162923.GA31680@spo001.leaseweb.nl \
    --to=wim@iguana.be \
    --cc=akshay.bhat@timesys.com \
    --cc=devicetree@vger.kernel.org \
    --cc=festevam@gmail.com \
    --cc=galak@codeaurora.org \
    --cc=ijc+devicetree@hellion.org.uk \
    --cc=justin.waters@timesys.com \
    --cc=kernel@pengutronix.de \
    --cc=l.stach@pengutronix.de \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-watchdog@vger.kernel.org \
    --cc=linux@arm.linux.org.uk \
    --cc=linux@roeck-us.net \
    --cc=mark.rutland@arm.com \
    --cc=pawel.moll@arm.com \
    --cc=robh+dt@kernel.org \
    --cc=shawnguo@kernel.org \
    --cc=sr@denx.de \
    --cc=tharvey@gateworks.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox

all inboxes | Powered by JetHome®