From: Michal Hocko <mhocko@kernel.org>
To: Vlastimil Babka <vbabka@suse.cz>
Cc: Andrew Morton <akpm@linux-foundation.org>,
linux-mm@kvack.org, linux-kernel@vger.kernel.org,
Mel Gorman <mgorman@techsingularity.net>,
Joonsoo Kim <iamjoonsoo.kim@lge.com>,
David Rientjes <rientjes@google.com>,
Rik van Riel <riel@redhat.com>
Subject: Re: [PATCH v2 16/18] mm, compaction: require only min watermarks for non-costly orders
Date: Wed, 1 Jun 2016 16:08:01 +0200 [thread overview]
Message-ID: <20160601140801.GV26601@dhcp22.suse.cz> (raw)
In-Reply-To: <20160531130818.28724-17-vbabka@suse.cz>
On Tue 31-05-16 15:08:16, Vlastimil Babka wrote:
> The __compaction_suitable() function checks the low watermark plus a
> compact_gap() gap to decide if there's enough free memory to perform
> compaction. Then __isolate_free_page uses low watermark check to decide if
> particular free page can be isolated. In the latter case, using low watermark
> is needlessly pessimistic, as the free page isolations are only temporary. For
> __compaction_suitable() the higher watermark makes sense for high-order
> allocations where more freepages increase the chance of success, and we can
> typically fail with some order-0 fallback when the system is struggling to
> reach that watermark. But for low-order allocation, forming the page should not
> be that hard. So using low watermark here might just prevent compaction from
> even trying, and eventually lead to OOM killer even if we are above min
> watermarks.
>
> So after this patch, we use min watermark for non-costly orders in
> __compaction_suitable(), and for all orders in __isolate_free_page().
>
> Signed-off-by: Vlastimil Babka <vbabka@suse.cz>
Acked-by: Michal Hocko <mhocko@suse.com>
> ---
> mm/compaction.c | 6 +++++-
> mm/page_alloc.c | 2 +-
> 2 files changed, 6 insertions(+), 2 deletions(-)
>
> diff --git a/mm/compaction.c b/mm/compaction.c
> index 4ffa0870192b..d854519a5302 100644
> --- a/mm/compaction.c
> +++ b/mm/compaction.c
> @@ -1345,10 +1345,14 @@ static enum compact_result __compaction_suitable(struct zone *zone, int order,
> * isolation. We however do use the direct compactor's classzone_idx to
> * skip over zones where lowmem reserves would prevent allocation even
> * if compaction succeeds.
> + * For costly orders, we require low watermark instead of min for
> + * compaction to proceed to increase its chances.
> * ALLOC_CMA is used, as pages in CMA pageblocks are considered
> * suitable migration targets
> */
> - watermark = low_wmark_pages(zone) + compact_gap(order);
> + watermark = (order > PAGE_ALLOC_COSTLY_ORDER) ?
> + low_wmark_pages(zone) : min_wmark_pages(zone);
> + watermark += compact_gap(order);
> if (!__zone_watermark_ok(zone, 0, watermark, classzone_idx,
> ALLOC_CMA, wmark_target))
> return COMPACT_SKIPPED;
> diff --git a/mm/page_alloc.c b/mm/page_alloc.c
> index 09dc9db8a7e9..5b4c9e567fc1 100644
> --- a/mm/page_alloc.c
> +++ b/mm/page_alloc.c
> @@ -2489,7 +2489,7 @@ int __isolate_free_page(struct page *page, unsigned int order)
>
> if (!is_migrate_isolate(mt)) {
> /* Obey watermarks as if the page was being allocated */
> - watermark = low_wmark_pages(zone) + (1 << order);
> + watermark = min_wmark_pages(zone) + (1UL << order);
> if (!zone_watermark_ok(zone, 0, watermark, 0, ALLOC_CMA))
> return 0;
>
> --
> 2.8.3
--
Michal Hocko
SUSE Labs
next prev parent reply other threads:[~2016-06-01 14:08 UTC|newest]
Thread overview: 32+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-05-31 13:08 [PATCH v2 00/18] make direct compaction more deterministic Vlastimil Babka
2016-05-31 13:08 ` [PATCH v2 01/18] mm, compaction: don't isolate PageWriteback pages in MIGRATE_SYNC_LIGHT mode Vlastimil Babka
2016-05-31 13:08 ` [PATCH v2 02/18] mm, page_alloc: set alloc_flags only once in slowpath Vlastimil Babka
2016-05-31 13:08 ` [PATCH v2 03/18] mm, page_alloc: don't retry initial attempt " Vlastimil Babka
2016-06-01 13:26 ` Michal Hocko
2016-06-01 14:58 ` Vlastimil Babka
2016-05-31 13:08 ` [PATCH v2 04/18] mm, page_alloc: restructure direct compaction handling " Vlastimil Babka
2016-05-31 13:08 ` [PATCH v2 05/18] mm, page_alloc: make THP-specific decisions more generic Vlastimil Babka
2016-05-31 13:08 ` [PATCH v2 06/18] mm, thp: remove __GFP_NORETRY from khugepaged and madvised allocations Vlastimil Babka
2016-06-01 13:33 ` Michal Hocko
2016-05-31 13:08 ` [PATCH v2 07/18] mm, compaction: introduce direct compaction priority Vlastimil Babka
2016-05-31 13:08 ` [PATCH v2 08/18] mm, compaction: simplify contended compaction handling Vlastimil Babka
2016-05-31 13:08 ` [PATCH v2 09/18] mm, compaction: make whole_zone flag ignore cached scanner positions Vlastimil Babka
2016-05-31 13:08 ` [PATCH v2 10/18] mm, compaction: cleanup unused functions Vlastimil Babka
2016-06-01 13:45 ` Michal Hocko
2016-05-31 13:08 ` [PATCH v2 11/18] mm, compaction: add the ultimate direct compaction priority Vlastimil Babka
2016-05-31 13:08 ` [PATCH v2 12/18] mm, compaction: more reliably increase " Vlastimil Babka
2016-06-01 13:51 ` Michal Hocko
2016-06-23 14:41 ` Vlastimil Babka
2016-05-31 13:08 ` [PATCH v2 13/18] mm, compaction: use correct watermark when checking allocation success Vlastimil Babka
2016-06-01 13:59 ` Michal Hocko
2016-05-31 13:08 ` [PATCH v2 14/18] mm, compaction: create compact_gap wrapper Vlastimil Babka
2016-06-01 14:02 ` Michal Hocko
2016-05-31 13:08 ` [PATCH v2 15/18] mm, compaction: use proper alloc_flags in __compaction_suitable() Vlastimil Babka
2016-05-31 13:08 ` [PATCH v2 16/18] mm, compaction: require only min watermarks for non-costly orders Vlastimil Babka
2016-06-01 14:08 ` Michal Hocko [this message]
2016-05-31 13:08 ` [PATCH v2 17/18] mm, vmscan: make compaction_ready() more accurate and readable Vlastimil Babka
2016-06-01 14:14 ` Michal Hocko
2016-05-31 13:08 ` [PATCH v2 18/18] mm, vmscan: use proper classzone_idx in should_continue_reclaim() Vlastimil Babka
2016-06-01 14:21 ` Michal Hocko
2016-06-01 15:19 ` Vlastimil Babka
2016-06-01 15:45 ` Michal Hocko
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20160601140801.GV26601@dhcp22.suse.cz \
--to=mhocko@kernel.org \
--cc=akpm@linux-foundation.org \
--cc=iamjoonsoo.kim@lge.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mm@kvack.org \
--cc=mgorman@techsingularity.net \
--cc=riel@redhat.com \
--cc=rientjes@google.com \
--cc=vbabka@suse.cz \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®