[PATCH] README: Mention when 386 support ended + update obsolete 386 paths

["Øyvind A. Holm" <sunny@sunbase.org>]

The paragraph about i386 could be misinterpreted as if 386 still is a
valid processor type. Mention when 386 support ended, and change two
"arch/i386/" paths to one that exists, "arch/x86/".

Signed-off-by: Øyvind A. Holm <sunny@sunbase.org>
---
 README | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/README b/README
index e8c8a6d..2c5c125 100644
--- a/README
+++ b/README
@@ -231,7 +231,8 @@ CONFIGURING the kernel:
 
     - Compiling the kernel with "Processor type" set higher than 386
       will result in a kernel that does NOT work on a 386.  The
-      kernel will detect this on bootup, and give up.
+      kernel will detect this on bootup, and give up. The last kernel
+      with support for 386 was version 3.7.
 
     - A kernel with math-emulation compiled in will still use the
       coprocessor if one is present: the math emulation will just
@@ -289,7 +290,7 @@ COMPILING the kernel:
    LOCALVERSION can be set in the "General Setup" menu.
 
  - In order to boot your new kernel, you'll need to copy the kernel
-   image (e.g. .../linux/arch/i386/boot/bzImage after compilation)
+   image (e.g. .../linux/arch/x86/boot/bzImage after compilation)
    to the place where your regular bootable kernel is found.
 
  - Booting a kernel directly from a floppy without the assistance of a
@@ -391,7 +392,7 @@ IF SOMETHING GOES WRONG:
 
  - Alternatively, you can use gdb on a running kernel. (read-only; i.e. you
    cannot change values or set break points.) To do this, first compile the
-   kernel with -g; edit arch/i386/Makefile appropriately, then do a "make
+   kernel with -g; edit arch/x86/Makefile appropriately, then do a "make
    clean". You'll also need to enable CONFIG_PROC_FS (via "make config").
 
    After you've rebooted with the new kernel, do "gdb vmlinux /proc/kcore".
-- 
2.9.2.466.g8c6d1f9