[PATCH 1/2] drm/vc4: Fix termination of the initial scan for branch targets.

[Eric Anholt <eric@anholt.net>]

The loop is scanning until the original max_ip (size of the BO), but
we want to not examine any code after the PROG_END's delay slots.
There was a block trying to do that, except that we had some early
continue statements if the signal wasn't a PROG_END or a BRANCH.

The failure mode would be that a valid shader is rejected because some
undefined memory after the PROG_END slots is parsed as a branch and
the rest of its setup is illegal.  I haven't seen this in the wild,
but valgrind was complaining when about this up in the userland
simulator mode.

Signed-off-by: Eric Anholt <eric@anholt.net>
---
 drivers/gpu/drm/vc4/vc4_validate_shaders.c | 19 ++++++++-----------
 1 file changed, 8 insertions(+), 11 deletions(-)

diff --git a/drivers/gpu/drm/vc4/vc4_validate_shaders.c b/drivers/gpu/drm/vc4/vc4_validate_shaders.c
index 2543cf5b8b51..917321ce832f 100644
--- a/drivers/gpu/drm/vc4/vc4_validate_shaders.c
+++ b/drivers/gpu/drm/vc4/vc4_validate_shaders.c
@@ -608,9 +608,7 @@ static bool
 vc4_validate_branches(struct vc4_shader_validation_state *validation_state)
 {
 	uint32_t max_branch_target = 0;
-	bool found_shader_end = false;
 	int ip;
-	int shader_end_ip = 0;
 	int last_branch = -2;
 
 	for (ip = 0; ip < validation_state->max_ip; ip++) {
@@ -621,8 +619,13 @@ vc4_validate_branches(struct vc4_shader_validation_state *validation_state)
 		uint32_t branch_target_ip;
 
 		if (sig == QPU_SIG_PROG_END) {
-			shader_end_ip = ip;
-			found_shader_end = true;
+			/* There are two delay slots after program end is
+			 * signaled that are still executed, then we're
+			 * finished.  validation_state->max_ip is the
+			 * instruction after the last valid instruction in the
+			 * program.
+			 */
+			validation_state->max_ip = ip + 3;
 			continue;
 		}
 
@@ -676,15 +679,9 @@ vc4_validate_branches(struct vc4_shader_validation_state *validation_state)
 		}
 		set_bit(after_delay_ip, validation_state->branch_targets);
 		max_branch_target = max(max_branch_target, after_delay_ip);
-
-		/* There are two delay slots after program end is signaled
-		 * that are still executed, then we're finished.
-		 */
-		if (found_shader_end && ip == shader_end_ip + 2)
-			break;
 	}
 
-	if (max_branch_target > shader_end_ip) {
+	if (max_branch_target > validation_state->max_ip - 3) {
 		DRM_ERROR("Branch landed after QPU_SIG_PROG_END");
 		return false;
 	}
-- 
2.10.1