From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S934085AbdA0R3e (ORCPT ); Fri, 27 Jan 2017 12:29:34 -0500 Received: from mail-wm0-f52.google.com ([74.125.82.52]:38713 "EHLO mail-wm0-f52.google.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S934044AbdA0R3L (ORCPT ); Fri, 27 Jan 2017 12:29:11 -0500 From: Lee Jones To: gregkh@linuxfoundation.org, jslaby@suse.com, linux-serial@vger.kernel.org, dt@kernel.org, devicetree@vger.kernel.org Cc: linux-arm-kernel@lists.infradead.org, linux-kernel@vger.kernel.org, kernel@stlinux.com, patrice.chotard@st.com, Lee Jones Subject: [PATCH v2 07/10] ARM: dts: STiH410-b2260: Identify the UART RTS line Date: Fri, 27 Jan 2017 17:28:01 +0000 Message-Id: <20170127172804.23881-8-lee.jones@linaro.org> X-Mailer: git-send-email 2.9.3 In-Reply-To: <20170127172804.23881-1-lee.jones@linaro.org> References: <20170127172804.23881-1-lee.jones@linaro.org> Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org When hardware flow-control is disabled, manual toggling of the UART's reset line (RTS) using userland applications (e.g. stty) is not possible, since the ASC IP does not provide this functionality in the same was as some other IPs do. Thus, we have to do this manually. This patch configures the UART RTS line as a GPIO for manipulation within the UART driver when HW flow-control is not enabled. Signed-off-by: Lee Jones --- arch/arm/boot/dts/stih410-b2260.dts | 1 + 1 file changed, 1 insertion(+) diff --git a/arch/arm/boot/dts/stih410-b2260.dts b/arch/arm/boot/dts/stih410-b2260.dts index 06b0696..fa16aba 100644 --- a/arch/arm/boot/dts/stih410-b2260.dts +++ b/arch/arm/boot/dts/stih410-b2260.dts @@ -63,6 +63,7 @@ uart0: serial@9830000 { label = "LS-UART0"; status = "okay"; + rts-gpios = <&pio17 3 GPIO_ACTIVE_LOW>; }; /* Low speed expansion connector */ -- 2.9.3