[linux-next][PATCH] usb: dwc3: core: Call dwc3_core_get_phy() before initializing phys

[Vignesh R <vigneshr@ti.com>]

commit f54edb539c116 ("usb: dwc3: core: initialize ULPI before trying to
get the PHY") moved call to dwc3_core_get_phy() from dwc3_probe() to
dwc3_core_init() after dwc3_core_soft_reset(). But
dwc3_core_soft_reset() calls phy_init(), therefore dwc3_core_get_phy()
needs to be called before dwc3_core_soft_reset().

Fix this by moving call to dwc3_core_get_phy() before
dwc3_core_soft_reset().

This fixes the following abort seen on DRA7xx platforms
[   24.769118] usb usb2: SerialNumber: xhci-hcd.1.auto
[   24.781144] hub 2-0:1.0: USB hub found
[   24.787836] hub 2-0:1.0: 1 port detected
[   24.809939] Unhandled fault: imprecise external abort (0x1406) at 0x00000000

Reported-by: Carlos Hernandez <ceh@ti.com>
Signed-off-by: Vignesh R <vigneshr@ti.com>
---
 drivers/usb/dwc3/core.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/usb/dwc3/core.c b/drivers/usb/dwc3/core.c
index 326b302fc440..03474d3575ab 100644
--- a/drivers/usb/dwc3/core.c
+++ b/drivers/usb/dwc3/core.c
@@ -766,15 +766,15 @@ static int dwc3_core_init(struct dwc3 *dwc)
 			dwc->maximum_speed = USB_SPEED_HIGH;
 	}
 
-	ret = dwc3_core_soft_reset(dwc);
+	ret = dwc3_core_get_phy(dwc);
 	if (ret)
 		goto err0;
 
-	ret = dwc3_phy_setup(dwc);
+	ret = dwc3_core_soft_reset(dwc);
 	if (ret)
 		goto err0;
 
-	ret = dwc3_core_get_phy(dwc);
+	ret = dwc3_phy_setup(dwc);
 	if (ret)
 		goto err0;
 
-- 
2.13.0