Re: [PATCH v4 0/5] flow_dissector: Provide basic batman-adv unicast handling

[David Miller <davem@davemloft.net>]

From: Sven Eckelmann <sven.eckelmann@openmesh.com>
Date: Thu, 21 Dec 2017 10:17:37 +0100

> we are currently starting to use batman-adv as mesh protocol on multicore
> embedded devices. These usually don't have a lot of CPU power per core but
> are reasonable fast when using multiple cores.
> 
> It was noticed that sending was working very well but receiving was
> basically only using on CPU core per neighbor. The reason for that is
> format of the (normal) incoming packet:
> 
>   +--------------------+
>   | ip(v6)hdr          |
>   +--------------------+
>   | inner ethhdr       |
>   +--------------------+
>   | batadv unicast hdr |
>   +--------------------+
>   | outer ethhdr       |
>   +--------------------+
> 
> The flow dissector will therefore stop after parsing the outer ethernet
> header and will not parse the actual ipv(4|6)/... header of the packet. Our
> assumption was now that it would help us to add minimal support to the flow
> dissector to jump over the batman-adv unicast and inner ethernet header
> (like in gre ETH_P_TEB). The patch was implemented in a slightly hacky
> way [1] and the results looked quite promising.
> 
> I didn't get any feedback how the files should actually be named. So I am
> now just using the names from RFC v3
> 
> The discussion of the RFC v3 can be found in the related patches of
> https://patchwork.ozlabs.org/cover/849345/
> 
> The discussion of the RFC v2 can be found in the related patches of
> https://patchwork.ozlabs.org/cover/844783/

Series applied, thanks!