Re: [PATCH 2/2] watchdog: aspeed: Allow configuring for alternate boot

[Guenter Roeck <linux@roeck-us.net>]

On Fri, Mar 09, 2018 at 03:58:20PM -0600, Eddie James wrote:
> From: Milton Miller <miltonm@us.ibm.com>
> 
> Allow the device tree to specify a watchdog to fallover to
> the alternate boot source.
> 
> The aspeeed watchdog can set a latch directing flash chip select 0 to
> chip select 1, allowing boot from an alternate media if the watchdog
> is not reset in time.  On the ast2400 bank 1 also goes to flash bank 1,
> while on the ast2500 the chip selects are swapped.
> 
> Signed-off-by: Milton Miller <miltonm@us.ibm.com>
> Signed-off-by: Eddie James <eajames@linux.vnet.ibm.com>

This is already documented in the bindings document, so the property
should be ok.

Reviewed-by: Guenter Roeck <linux@roeck-us.net>

> ---
>  drivers/watchdog/aspeed_wdt.c | 3 +++
>  1 file changed, 3 insertions(+)
> 
> diff --git a/drivers/watchdog/aspeed_wdt.c b/drivers/watchdog/aspeed_wdt.c
> index d1987d6..f41d246 100644
> --- a/drivers/watchdog/aspeed_wdt.c
> +++ b/drivers/watchdog/aspeed_wdt.c
> @@ -46,6 +46,7 @@ struct aspeed_wdt_config {
>  #define WDT_RELOAD_VALUE	0x04
>  #define WDT_RESTART		0x08
>  #define WDT_CTRL		0x0C
> +#define   WDT_CTRL_BOOT_SECONDARY	BIT(7)
>  #define   WDT_CTRL_RESET_MODE_SOC	(0x00 << 5)
>  #define   WDT_CTRL_RESET_MODE_FULL_CHIP	(0x01 << 5)
>  #define   WDT_CTRL_RESET_MODE_ARM_CPU	(0x10 << 5)
> @@ -245,6 +246,8 @@ static int aspeed_wdt_probe(struct platform_device *pdev)
>  	}
>  	if (of_property_read_bool(np, "aspeed,external-signal"))
>  		wdt->ctrl |= WDT_CTRL_WDT_EXT;
> +	if (of_property_read_bool(np, "aspeed,alt-boot"))
> +		wdt->ctrl |= WDT_CTRL_BOOT_SECONDARY;
>  
>  	if (readl(wdt->base + WDT_CTRL) & WDT_CTRL_ENABLE)  {
>  		/*
> -- 
> 1.8.3.1
>