From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S1758016AbeD0Lrk (ORCPT ); Fri, 27 Apr 2018 07:47:40 -0400 Received: from lelnx193.ext.ti.com ([198.47.27.77]:48795 "EHLO lelnx193.ext.ti.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1757153AbeD0Lri (ORCPT ); Fri, 27 Apr 2018 07:47:38 -0400 From: Kishon Vijay Abraham I To: Ulf Hansson , Adrian Hunter CC: Rob Herring , Mark Rutland , , , , , Subject: [PATCH v5 00/14] mmc: sdhci-omap: Add UHS/HS200 mode support Date: Fri, 27 Apr 2018 17:17:09 +0530 Message-ID: <20180427114723.2687-1-kishon@ti.com> X-Mailer: git-send-email 2.17.0 MIME-Version: 1.0 Content-Type: text/plain; charset="UTF-8" Content-Transfer-Encoding: 8bit X-EXCLAIMER-MD-CONFIG: e1e8a2fd-e40a-4ac6-ac9b-f7e9cc9ee180 Sender: linux-kernel-owner@vger.kernel.org List-ID: X-Mailing-List: linux-kernel@vger.kernel.org Add UHS/HS200 mode support in sdhci-omap. The programming sequence for voltage switching, tuning is followed from AM572x TRM http://www.ti.com/lit/ug/spruhz6j/spruhz6j.pdf (Similar to all AM57x/DRA7x SoCs). The patch series also implements workaround for errata published in http://www.ti.com/lit/er/sprz429l/sprz429l.pdf patches are created on top of git://git.kernel.org/pub/scm/linux/kernel/git/ulfh/mmc.git next The patches along with dt has also been pushed to https://github.com/kishon/linux-wip.git sdhci_uhs_v5 Changes from v4: *) Added comment in sdhci for disabling HS200/HS400 mode *) Fixed a couple of chunks in "Program a relatively accurate SW timeout value" which were missed in the previous revision *) Added a patch in sdhci-omap to get IODelay values of 3.3v DDR mode. *) Added pinctrl binding documentation for sdhci-omap which was missed before. Changes from v3: *) Fixed Adrian's comment on error handling when __sdhci_add_host() fails *) Used Adrian's patches for programming SW timeout value. Changes from v2: *) Patches in v2 already applied to mmc -next are dropped from the series. *) Changed SW timeout logic as per Adrians's suggestion *) Validated SDIO with the current patches (added a couple of fixes found while adding SDIO support). *) Used soc_device_match() instead of pdata-quirks as per Tony's suggestions. Changes from v1: *) Only poll on DAT0 and DATI for card_busy status *) Cleanup iodelay patch as suggested by Tony. *) Added quirk to disable HW timeout *) Use the existing data timer but program a relatively accurate SW timeout value (Impacts all platforms) *) Fix a bug in sdhci which was using data_timer for non data line commands Adrian Hunter (2): mmc: sdhci: Add quirk to disable HW timeout mmc: sdhci: Factor out target_timeout calculation Kishon Vijay Abraham I (12): mmc: sdhci-omap: Fix when capabilities are obtained from SDHCI_CAPABILITIES reg mmc: sdhci-omap: Remove setting ADMA capability in driver mmc: sdhci-omap: Workaround for Errata i843 mmc: sdhci-omap: Invoke sdhci_get_of_property to read sdhci dt properties mmc: sdhci: Disable 1.8v modes (HS200/HS400/UHS) if controller can't support 1.8v mmc: sdhci: Program a relatively accurate SW timeout value mmc: sdhci-omap: Workaround for Errata i834 dt-bindings: sdhci-omap: Add K2G specific binding mmc: sdhci-omap: Add support for MMC/SD controller in k2g SoC mmc: sdhci-omap: Add sdhci_omap specific ops for enable_sdio_irq dt-bindings: sdhci-omap: Add pinctrl bindings mmc: sdhci-omap: Get IODelay values for 3.3v DDR mode .../devicetree/bindings/mmc/sdhci-omap.txt | 7 + drivers/mmc/host/sdhci-omap.c | 92 +++++++++-- drivers/mmc/host/sdhci.c | 148 ++++++++++++++---- drivers/mmc/host/sdhci.h | 15 ++ include/linux/mmc/host.h | 4 + 5 files changed, 226 insertions(+), 40 deletions(-) -- 2.17.0