[PATCH] md/raid1: add error handling of read error from FailFast device

[Gioh Kim <gi-oh.kim@profitbricks.com>]

Current handle_read_error() function calls fix_read_error()
only if md device is RW and rdev does not include FailFast flag.
It does not handle a read error from a RW device including
FailFast flag.

I am not sure it is intended. But I found that write IO error
sets rdev faulty. The md module should handle the read IO error and
write IO error equally. So I think read IO error should set rdev faulty.

Signed-off-by: Gioh Kim <gi-oh.kim@profitbricks.com>
---
 drivers/md/raid1.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/md/raid1.c b/drivers/md/raid1.c
index e9e3308cb0a7..4445179aa4c8 100644
--- a/drivers/md/raid1.c
+++ b/drivers/md/raid1.c
@@ -2474,6 +2474,8 @@ static void handle_read_error(struct r1conf *conf, struct r1bio *r1_bio)
 		fix_read_error(conf, r1_bio->read_disk,
 			       r1_bio->sector, r1_bio->sectors);
 		unfreeze_array(conf);
+	} else if (mddev->ro == 0 && test_bit(FailFast, &rdev->flags)) {
+		md_error(mddev, rdev);
 	} else {
 		r1_bio->bios[r1_bio->read_disk] = IO_BLOCKED;
 	}
-- 
2.14.1