[PATCH] usb: phy: twl6030-usb: fix possible use-after-free on remove

[Sven Van Asbroeck <thesven73@gmail.com>]

In remove(), use cancel_delayed_work_sync() to cancel the
delayed work. Otherwise there's a chance that this work
will continue to run until after the device has been removed.

This issue was detected with the help of Coccinelle.

Cc: Tony Lindgren <tony@atomide.com>
Cc: Bin Liu <b-liu@ti.com>
Fixes: b6a619a883c3 ("usb: phy: Check initial state for twl6030")
Signed-off-by: Sven Van Asbroeck <TheSven73@gmail.com>
---
 drivers/usb/phy/phy-twl6030-usb.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/usb/phy/phy-twl6030-usb.c b/drivers/usb/phy/phy-twl6030-usb.c
index 183550b63faa..dade34d70419 100644
--- a/drivers/usb/phy/phy-twl6030-usb.c
+++ b/drivers/usb/phy/phy-twl6030-usb.c
@@ -400,7 +400,7 @@ static int twl6030_usb_remove(struct platform_device *pdev)
 {
 	struct twl6030_usb *twl = platform_get_drvdata(pdev);
 
-	cancel_delayed_work(&twl->get_status_work);
+	cancel_delayed_work_sync(&twl->get_status_work);
 	twl6030_interrupt_mask(TWL6030_USBOTG_INT_MASK,
 		REG_INT_MSK_LINE_C);
 	twl6030_interrupt_mask(TWL6030_USBOTG_INT_MASK,
-- 
2.17.1