[PATCH AUTOSEL 3.18 2/5] irqchip/mmp: Only touch the PJ4 IRQ & FIQ bits on enable/disable

[Sasha Levin <sashal@kernel.org>]

From: Lubomir Rintel <lkundrak@v3.sk>

[ Upstream commit 2380a22b60ce6f995eac806e69c66e397b59d045 ]

Resetting bit 4 disables the interrupt delivery to the "secure
processor" core. This breaks the keyboard on a OLPC XO 1.75 laptop,
where the firmware running on the "secure processor" bit-bangs the
PS/2 protocol over the GPIO lines.

It is not clear what the rest of the bits are and Marvell was unhelpful
when asked for documentation. Aside from the SP bit, there are probably
priority bits.

Leaving the unknown bits as the firmware set them up seems to be a wiser
course of action compared to just turning them off.

Signed-off-by: Lubomir Rintel <lkundrak@v3.sk>
Acked-by: Pavel Machek <pavel@ucw.cz>
[maz: fixed-up subject and commit message]
Signed-off-by: Marc Zyngier <marc.zyngier@arm.com>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/irqchip/irq-mmp.c | 6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/drivers/irqchip/irq-mmp.c b/drivers/irqchip/irq-mmp.c
index c0da57bdb89df..7924d21c86ecb 100644
--- a/drivers/irqchip/irq-mmp.c
+++ b/drivers/irqchip/irq-mmp.c
@@ -35,6 +35,9 @@
 #define SEL_INT_PENDING		(1 << 6)
 #define SEL_INT_NUM_MASK	0x3f
 
+#define MMP2_ICU_INT_ROUTE_PJ4_IRQ	(1 << 5)
+#define MMP2_ICU_INT_ROUTE_PJ4_FIQ	(1 << 6)
+
 struct icu_chip_data {
 	int			nr_irqs;
 	unsigned int		virq_base;
@@ -191,7 +194,8 @@ static struct mmp_intc_conf mmp_conf = {
 static struct mmp_intc_conf mmp2_conf = {
 	.conf_enable	= 0x20,
 	.conf_disable	= 0x0,
-	.conf_mask	= 0x7f,
+	.conf_mask	= MMP2_ICU_INT_ROUTE_PJ4_IRQ |
+			  MMP2_ICU_INT_ROUTE_PJ4_FIQ,
 };
 
 static void __exception_irq_entry mmp_handle_irq(struct pt_regs *regs)
-- 
2.19.1