Re: [RFC PATCH v2 1/2] x86/perf/amd: Resolve race condition when disabling PMC

[Peter Zijlstra <peterz@infradead.org>]

On Fri, Mar 15, 2019 at 08:40:53PM +0000, Lendacky, Thomas wrote:
> +void amd_pmu_disable_all(void)
> +{
> +	unsigned long overflow_check[BITS_TO_LONGS(X86_PMC_IDX_MAX)];
> +	struct cpu_hw_events *cpuc = this_cpu_ptr(&cpu_hw_events);
> +	int idx;
> +
> +	bitmap_zero(overflow_check, X86_PMC_IDX_MAX);
> +
> +	for (idx = 0; idx < x86_pmu.num_counters; idx++) {
> +		u64 val;
> +
> +		if (!test_bit(idx, cpuc->active_mask))
> +			continue;
> +
> +		rdmsrl(x86_pmu_config_addr(idx), val);
> +		if (!(val & ARCH_PERFMON_EVENTSEL_ENABLE))
> +			continue;
> +
> +		val &= ~ARCH_PERFMON_EVENTSEL_ENABLE;
> +		wrmsrl(x86_pmu_config_addr(idx), val);
> +
> +		/*
> +		 * If the interrupt is enabled, this counter must be checked
> +		 * for an overflow condition to avoid possibly changing the
> +		 * counter value before the NMI handler runs.
> +		 */
> +		if (val & ARCH_PERFMON_EVENTSEL_INT)
> +			__set_bit(idx, overflow_check);
> +	}

I think you can ditch overflow_check and directly call
x86_pmu_disable_all() here.

> +
> +	/*
> +	 * This shouldn't be called from NMI context, but add a safeguard here
> +	 * to return, since if we're in NMI context we can't wait for an NMI
> +	 * to reset an overflowed counter value.
> +	 */
> +	if (in_nmi())
> +		return;
> +
> +	/*
> +	 * Check each counter for overflow and wait for it to be reset by the
> +	 * NMI if it has overflowed.
> +	 */
> +	for (idx = 0; idx < x86_pmu.num_counters; idx++) {
> +		if (!test_bit(idx, overflow_check))

And simply iterate cpuc->active_mask again here.

> +			continue;
> +
> +		amd_pmu_wait_on_overflow(idx);
> +	}
> +}

Because, per x86_pmu_hw_config() we _always_ have EVENTSEL_INT set, even
for !sampling events -- such that we can deal with overflow, and we
should 'always' have EVENTSEL_ENABLE set when 'active', see
x86_pmu_enable_all().