[PATCH v1 10/11] dt-bindings: display/bridge: Add config property for ti949

[Michael Drake <michael.drake@codethink.co.uk>]

The config property can be used to provide an array of
register addresses and values to be written to configure
the device for the board.

Signed-off-by: Michael Drake <michael.drake@codethink.co.uk>
Cc: Patrick Glaser <pglaser@tesla.com>
Cc: Nate Case <ncase@tesla.com>
---
 .../bindings/display/bridge/ti,ds90ub949.txt        | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/Documentation/devicetree/bindings/display/bridge/ti,ds90ub949.txt b/Documentation/devicetree/bindings/display/bridge/ti,ds90ub949.txt
index 3ba3897d5e81..b1e38d732f17 100644
--- a/Documentation/devicetree/bindings/display/bridge/ti,ds90ub949.txt
+++ b/Documentation/devicetree/bindings/display/bridge/ti,ds90ub949.txt
@@ -12,6 +12,8 @@ Required properties:
 Optional properties:
 
 - regulators: List of regulator name strings to enable for operation of device.
+- config: List of <register address>,<value> pairs to be set to configure
+  device on powerup.  The register addresses and values are 8bit.
 
 Example
 -------
@@ -21,4 +23,15 @@ ti949: ds90ub949@0 {
 
 	regulators: "vcc",
 	            "vcc_hdmi";
+	config:
+	        /* GPIO0 is an output with remote value */
+	        <0x0D>, <0x25>,
+	        /* GPIO3 is an input for XRES */
+	        <0x0F>, <0x03>,
+	        /* GPIO2 is an input for backlight PWM */
+	        <0x0E>, <0x30>,
+	        /* Enables forward channel I2C pass through */
+	        <0x17>, <0x9e>,
+	        /* Enables PORT1 registers I2C access */
+	        <0x1E>, <0x04>;
 };
-- 
2.20.1