[PATCH net] net: bcmgenet: Set phydev->dev_flags only for internal PHYs

[Florian Fainelli <f.fainelli@gmail.com>]

phydev->dev_flags is entirely dependent on the PHY device driver which
is going to be used, setting the internal GENET PHY revision in those
bits only makes sense when drivers/net/phy/bcm7xxx.c is the PHY driver
being used.

Fixes: 487320c54143 ("net: bcmgenet: communicate integrated PHY revision to PHY driver")
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
---
 drivers/net/ethernet/broadcom/genet/bcmmii.c | 5 +++--
 1 file changed, 3 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/broadcom/genet/bcmmii.c b/drivers/net/ethernet/broadcom/genet/bcmmii.c
index 970e478a9017..94d1dd5d56bf 100644
--- a/drivers/net/ethernet/broadcom/genet/bcmmii.c
+++ b/drivers/net/ethernet/broadcom/genet/bcmmii.c
@@ -273,11 +273,12 @@ int bcmgenet_mii_probe(struct net_device *dev)
 	struct bcmgenet_priv *priv = netdev_priv(dev);
 	struct device_node *dn = priv->pdev->dev.of_node;
 	struct phy_device *phydev;
-	u32 phy_flags;
+	u32 phy_flags = 0;
 	int ret;
 
 	/* Communicate the integrated PHY revision */
-	phy_flags = priv->gphy_rev;
+	if (priv->internal_phy)
+		phy_flags = priv->gphy_rev;
 
 	/* Initialize link state variables that bcmgenet_mii_setup() uses */
 	priv->old_link = -1;
-- 
2.17.1