Re: [net-next,v1, 1/1] net: stmmac: Enable SERDES power up/down sequence

[David Miller <davem@davemloft.net>]

From: Voon Weifeng <weifeng.voon@intel.com>
Date: Mon, 20 Apr 2020 23:42:52 +0800

> This patch is to enable Intel SERDES power up/down sequence. The SERDES
> converts 8/10 bits data to SGMII signal. Below is an example of
> HW configuration for SGMII mode. The SERDES is located in the PHY IF
> in the diagram below.
> 
> <-----------------GBE Controller---------->|<--External PHY chip-->
> +----------+         +----+            +---+           +----------+
> |   EQoS   | <-GMII->| DW | < ------ > |PHY| <-SGMII-> | External |
> |   MAC    |         |xPCS|            |IF |           | PHY      |
> +----------+         +----+            +---+           +----------+
>        ^               ^                 ^                ^
>        |               |                 |                |
>        +---------------------MDIO-------------------------+
> 
> PHY IF configuration and status registers are accessible through
> mdio address 0x15 which is defined as mdio_adhoc_addr. During D0,
> The driver will need to power up PHY IF by changing the power state
> to P0. Likewise, for D3, the driver sets PHY IF power state to P3.
> 
> Signed-off-by: Voon Weifeng <weifeng.voon@intel.com>
> Signed-off-by: Ong Boon Leong <boon.leong.ong@intel.com>

Applied, thanks.