Re: [PATCH 6/6] mfd: lochnagar: Move binding over to dtschema

[Charles Keepax <ckeepax@opensource.cirrus.com>]

On Fri, May 01, 2020 at 03:47:21PM -0500, Rob Herring wrote:
> On Mon, Apr 27, 2020 at 10:36:14AM +0000, Charles Keepax wrote:
> > On Mon, Apr 27, 2020 at 11:28:12AM +0100, Charles Keepax wrote:
> > > Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
> > > ---
> > > +            lochnagar-pinctrl {
> > > +                compatible = "cirrus,lochnagar-pinctrl";
> > > +
> > > +                gpio-controller;
> > > +                #gpio-cells = <2>;
> > > +                gpio-ranges = <&lochnagar 0 0 LOCHNAGAR2_PIN_NUM_GPIOS>;
> > > +
> > > +                pinctrl-names = "default";
> > > +                pinctrl-0 = <&pinsettings>;
> > 
> > This seems to cause the following error:
> > 
> > Documentation/devicetree/bindings/mfd/cirrus,lochnagar.example.dt.yaml:
> > lochnagar@22: lochnagar-pinctrl:pin-settings:phandle: [[4]] is not of type 'object'
> > 
> > I think the schema is correct and the problem is one of tooling,
> > I have been poking at it for a while but can't seem to find a way
> > to silence this one. Any advice would be greatly appreciated.
> 
> The problem is the "^.*$" patterns to match child node names also match 
> properties like 'phandle'. Ideally, you'd have some pattern to match on 
> for the node names.
> 
> There is work-around doing:
> 
> "^.*$":
>   if:
>     type: object
>   then:
>     properties:
>       ...
> 

I believe I did try this and run into some other problems.

> But I much prefer to see node names updated. '-pins$' is a common 
> pattern.
> 

I have no problem requiring a pins suffix on the sub-nodes. Will
add that and send a new version, fixing up your other comments as
well. Thank you for your suggestions and review.

Thanks,
Charles