Re: [PATCH net-next v1] net: phy: at803x: add mdix configuration support for AR9331 and AR8035

[Andrew Lunn <andrew@lunn.ch>]

On Sun, Jul 19, 2020 at 10:05:30AM +0200, Oleksij Rempel wrote:
> This patch add MDIX configuration ability for AR9331 and AR8035. Theoretically
> it should work on other Atheros PHYs, but I was able to test only this
> two.
> 
> Since I have no certified reference HW able to detect or configure MDIX, this
> functionality was confirmed by oscilloscope.
> 
> Signed-off-by: Oleksij Rempel <o.rempel@pengutronix.de>
> ---
>  drivers/net/phy/at803x.c | 78 ++++++++++++++++++++++++++++++++++++++++
>  1 file changed, 78 insertions(+)
> 
> diff --git a/drivers/net/phy/at803x.c b/drivers/net/phy/at803x.c
> index 96c61aa75bd7..101651b2de54 100644
> --- a/drivers/net/phy/at803x.c
> +++ b/drivers/net/phy/at803x.c
> @@ -21,6 +21,17 @@
>  #include <linux/regulator/consumer.h>
>  #include <dt-bindings/net/qca-ar803x.h>
>  
> +#define AT803X_SPECIFIC_FUNCTION_CONTROL	0x10
> +#define AT803X_SFC_ASSERT_CRS			BIT(11)
> +#define AT803X_SFC_FORCE_LINK			BIT(10)
> +#define AT803X_SFC_MDI_CROSSOVER_MODE_M		GENMASK(6, 5)
> +#define AT803X_SFC_AUTOMATIC_CROSSOVER		0x3
> +#define AT803X_SFC_MANUAL_MDIX			0x1
> +#define AT803X_SFC_MANUAL_MDI			0x0

Interestingly, these are the same bits as for the Marvell PHY. I had a
quick look at 802.3. The functionality is standardized, but not the
registers.

Reviewed-by: Andrew Lunn <andrew@lunn.ch>

    Andrew