[PATCH v4 0/2] Add 802.1AD protocol support for dsa switch and ocelot driver

[hongbo.wang@nxp.com]

From: "hongbo.wang" <hongbo.wang@nxp.com>

1. the patch 0001* is for setting single port into 802.1AD(QinQ) mode,
before this patch, the function dsa_slave_vlan_rx_add_vid didn't pass 
the parameter "proto" to next port level, so switch's port can't get
parameter "proto"
  after applying this patch, the following command can be supported:
  ip link set br0 type bridge vlan_protocol 802.1ad
  ip link add link swp1 name swp1.100 type vlan protocol 802.1ad id 100

2. the patch 0002* is for setting QinQ related registers in ocelot 
switch driver, after applying this patch, the switch(VSC99599)'s port can
enable or disable QinQ mode.

3. Version log
v4: 
a. modify slave.c to support "ip set br0 type bridge vlan_protocol 802.1ad"
b. modify ocelot.c, if enable QinQ, set VLAN_AWARE_ENA and VLAN_POP_CNT per
   port when vlan_filter=1
v3: combine two patches to one post

hongbo.wang (2):
  net: dsa: Add protocol support for 802.1AD when adding or   deleting
    vlan for dsa switch port
  net: dsa: ocelot: Add support for QinQ Operation

 drivers/net/dsa/ocelot/felix.c     | 12 +++++++
 drivers/net/ethernet/mscc/ocelot.c | 53 +++++++++++++++++++++++++-----
 include/net/switchdev.h            |  1 +
 include/soc/mscc/ocelot.h          |  2 ++
 net/dsa/dsa_priv.h                 |  4 +--
 net/dsa/port.c                     |  6 ++--
 net/dsa/slave.c                    | 27 +++++++++++----
 net/dsa/tag_8021q.c                |  4 +--
 8 files changed, 89 insertions(+), 20 deletions(-)

-- 
2.17.1