Re: [PATCH v5 0/2] Add 802.1AD protocol support for dsa switch and ocelot driver

[David Miller <davem@davemloft.net>]

From: hongbo.wang@nxp.com
Date: Fri,  7 Aug 2020 19:13:47 +0800

> From: "hongbo.wang" <hongbo.wang@nxp.com>
> 
> 1. the patch 0001* is for setting single port into 802.1AD(QinQ) mode,
> before this patch, the function dsa_slave_vlan_rx_add_vid didn't pass 
> the parameter "proto" to next port level, so switch's port can't get
> parameter "proto"
>   after applying this patch, the following command can be supported:
>   ip link set br0 type bridge vlan_protocol 802.1ad
>   ip link add link swp1 name swp1.100 type vlan protocol 802.1ad id 100
> 
> 2. the patch 0002* is for setting QinQ related registers in ocelot 
> switch driver, after applying this patch, the switch(VSC99599)'s port can
> enable or disable QinQ mode.
> 
> 3. Version log
> v5:
> a. add devlink to enable qinq_mode of ocelot's single port
> b. modify br_switchdev_port_vlan_add to pass bridge's vlan_proto to port driver
> c. enable NETIF_F_HW_VLAN_STAG_FILTER in ocelot driver
> v4:
> a. modify slave.c to support "ip set br0 type bridge vlan_protocol 802.1ad"
> b. modify ocelot.c, if enable QinQ, set VLAN_AWARE_ENA and VLAN_POP_CNT per
>    port when vlan_filter=1
> v3: combine two patches to one post

Please defer new feature changes, like this, until the net-next tree is open
again.  It is closed right now.

Thank you.