Re: [PATCH] mmc: sdhci-pci-gli: increase 1.8V regulator wait

[Ben Chuang <benchuanggli@gmail.com>]

Hi Daniel,

> Inserting an SD-card on an Intel NUC10i3FNK4 (which contains a GL9755)
> results in the message:
> 
>     mmc0: 1.8V regulator output did not become stable
> 
> Following this message, some cards work (sometimes), but most cards fail
> with EILSEQ. This behaviour is observed on Debian 10 running kernel
> 4.19.188, but also with 5.8.18 and 5.11.15.

Glad to receive your report. Thanks.

> 
> The driver currently waits 5ms after switching on the 1.8V regulator for
> it to become stable. Increasing this to 10ms gets rid of the warning
> about stability, but most cards still fail. Increasing it to 20ms gets
> some cards working (a 32GB Samsung micro SD works, a 128GB ADATA
> doesn't). At 50ms, the ADATA works most of the time, and at 100ms both
> cards work reliably.

If it is convenient, can you provide the appearance pictures and product
links of these two cards? We want to buy them.

> 
> Signed-off-by: Daniel Beer <dlbeer@gmail.com>
> ---
>  drivers/mmc/host/sdhci-pci-gli.c | 7 ++++++-
>  1 file changed, 6 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/mmc/host/sdhci-pci-gli.c b/drivers/mmc/host/sdhci-pci-gli.c
> index 592d79082f58..061618aa247f 100644
> --- a/drivers/mmc/host/sdhci-pci-gli.c
> +++ b/drivers/mmc/host/sdhci-pci-gli.c
> @@ -627,8 +627,13 @@ static void sdhci_gli_voltage_switch(struct sdhci_host *host)
>  	 *
>  	 * Wait 5ms after set 1.8V signal enable in Host Control 2 register
>  	 * to ensure 1.8V signal enable bit is set by GL9750/GL9755.
> +	 *
> +	 * ...however, the controller in the NUC10i3FNK4 (a 9755) requires
> +	 * slightly longer than 5ms before the control register reports that
> +	 * 1.8V is ready, and far longer still before the card will actually
> +	 * work reliably.
>  	 */
> -	usleep_range(5000, 5500);
> +	usleep_range(100000, 110000);

Looks good for me.

>  }
>  
>  static void sdhci_gl9750_reset(struct sdhci_host *host, u8 mask)
> -- 
> 2.20.1
> 
> 

Best regards,
Ben