From: Charles Mirabile <cmirabil@redhat.com>
To: linux-kernel@vger.kernel.org
Cc: Charles Mirabile <cmirabil@redhat.com>,
Dmitry Torokhov <dmitry.torokhov@gmail.com>,
linux-input@vger.kernel.org,
Serge Schneider <serge@raspberrypi.org>,
Stefan Wahren <stefan.wahren@i2se.com>,
Nicolas Saenz Julienne <nsaenzju@redhat.com>,
Mattias Brugger <mbrugger@suse.com>,
linux-rpi-kernel@lists.infradead.org,
linux-arm-kernel@lists.infradead.org,
fedora-rpi@googlegroups.com, Mwesigwa Guma <mguma@redhat.com>,
Joel Savitz <jsavitz@redhat.com>
Subject: [PATCH V5 2/6] drivers/input/joystick: sensehat: Raspberry Pi Sense HAT joystick driver
Date: Fri, 10 Dec 2021 17:10:29 -0500 [thread overview]
Message-ID: <20211210221033.912430-3-cmirabil@redhat.com> (raw)
In-Reply-To: <20211210221033.912430-1-cmirabil@redhat.com>
This patch implements support for the joystick.
It supports left/right/up/down/enter and is
attached via i2c and a gpio pin for irq.
Signed-off-by: Charles Mirabile <cmirabil@redhat.com>
Co-developed-by: Mwesigwa Guma <mguma@redhat.com>
Signed-off-by: Mwesigwa Guma <mguma@redhat.com>
Co-developed-by: Joel Savitz <jsavitz@redhat.com>
Signed-off-by: Joel Savitz <jsavitz@redhat.com>
---
drivers/input/joystick/Kconfig | 8 ++
drivers/input/joystick/Makefile | 1 +
drivers/input/joystick/sensehat-joystick.c | 119 +++++++++++++++++++++
3 files changed, 128 insertions(+)
create mode 100644 drivers/input/joystick/sensehat-joystick.c
diff --git a/drivers/input/joystick/Kconfig b/drivers/input/joystick/Kconfig
index 3b23078bc7b5..d5c5ffe13903 100644
--- a/drivers/input/joystick/Kconfig
+++ b/drivers/input/joystick/Kconfig
@@ -399,4 +399,12 @@ config JOYSTICK_N64
Say Y here if you want enable support for the four
built-in controller ports on the Nintendo 64 console.
+config JOYSTICK_SENSEHAT
+ tristate "Raspberry Pi Sense HAT joystick"
+ depends on GPIOLIB && INPUT && I2C
+ select MFD_SENSEHAT_CORE
+
+ help
+ This is the joystick driver for the Raspberry Pi Sense HAT
+
endif
diff --git a/drivers/input/joystick/Makefile b/drivers/input/joystick/Makefile
index 5174b8aba2dd..39c8b5c6e5ae 100644
--- a/drivers/input/joystick/Makefile
+++ b/drivers/input/joystick/Makefile
@@ -28,6 +28,7 @@ obj-$(CONFIG_JOYSTICK_N64) += n64joy.o
obj-$(CONFIG_JOYSTICK_PSXPAD_SPI) += psxpad-spi.o
obj-$(CONFIG_JOYSTICK_PXRC) += pxrc.o
obj-$(CONFIG_JOYSTICK_QWIIC) += qwiic-joystick.o
+obj-$(CONFIG_JOYSTICK_SENSEHAT) += sensehat-joystick.o
obj-$(CONFIG_JOYSTICK_SIDEWINDER) += sidewinder.o
obj-$(CONFIG_JOYSTICK_SPACEBALL) += spaceball.o
obj-$(CONFIG_JOYSTICK_SPACEORB) += spaceorb.o
diff --git a/drivers/input/joystick/sensehat-joystick.c b/drivers/input/joystick/sensehat-joystick.c
new file mode 100644
index 000000000000..1f6bb09b4d1f
--- /dev/null
+++ b/drivers/input/joystick/sensehat-joystick.c
@@ -0,0 +1,119 @@
+// SPDX-License-Identifier: GPL-2.0-or-later
+/*
+ * Raspberry Pi Sense HAT joystick driver
+ * http://raspberrypi.org
+ *
+ * Copyright (C) 2015 Raspberry Pi
+ * Copyright (C) 2021 Charles Mirabile, Mwesigwa Guma, Joel Savitz
+ *
+ * Original Author: Serge Schneider
+ * Revised for upstream Linux by: Charles Mirabile, Mwesigwa Guma, Joel Savitz
+ */
+
+#include <linux/module.h>
+#include <linux/input.h>
+#include <linux/i2c.h>
+#include <linux/interrupt.h>
+#include <linux/gpio/consumer.h>
+#include <linux/platform_device.h>
+#include <linux/regmap.h>
+#include <linux/mfd/sensehat.h>
+
+#define SENSEHAT_KEYS 0xF2
+
+static int sensehat_get_joystick_state(struct sensehat *sensehat);
+
+static unsigned char keymap[] = {
+ KEY_DOWN, KEY_RIGHT, KEY_UP, KEY_ENTER, KEY_LEFT,
+};
+
+static irqreturn_t sensehat_joystick_report(int n, void *cookie)
+{
+ int i;
+ static s32 prev_keys;
+ struct sensehat *sensehat = cookie;
+ struct sensehat_joystick *sensehat_joystick = &sensehat->joystick;
+ s32 keys = sensehat_get_joystick_state(sensehat);
+ s32 changes = keys ^ prev_keys;
+
+ prev_keys = keys;
+ for (i = 0; i < ARRAY_SIZE(keymap); ++i) {
+ if (changes & (1 << i)) {
+ input_report_key(sensehat_joystick->keys_dev, keymap[i],
+ keys & (1 << i));
+ }
+ }
+ input_sync(sensehat_joystick->keys_dev);
+ return IRQ_HANDLED;
+}
+
+static int sensehat_joystick_probe(struct platform_device *pdev)
+{
+ int ret;
+ int i;
+ struct sensehat *sensehat = dev_get_drvdata(&pdev->dev);
+ struct sensehat_joystick *sensehat_joystick = &sensehat->joystick;
+
+ sensehat_joystick->keys_dev = devm_input_allocate_device(&pdev->dev);
+ if (!sensehat_joystick->keys_dev) {
+ dev_err(&pdev->dev, "Could not allocate input device.\n");
+ return -ENOMEM;
+ }
+
+ for (i = 0; i < ARRAY_SIZE(keymap); i++) {
+ set_bit(keymap[i], sensehat_joystick->keys_dev->keybit);
+ }
+
+ sensehat_joystick->keys_dev->name = "Raspberry Pi Sense HAT Joystick";
+ sensehat_joystick->keys_dev->phys = "rpi-sense-joy/input0";
+ sensehat_joystick->keys_dev->id.bustype = BUS_I2C;
+ sensehat_joystick->keys_dev->evbit[0] =
+ BIT_MASK(EV_KEY) | BIT_MASK(EV_REP);
+ sensehat_joystick->keys_dev->keycode = keymap;
+ sensehat_joystick->keys_dev->keycodesize = sizeof(unsigned char);
+ sensehat_joystick->keys_dev->keycodemax = ARRAY_SIZE(keymap);
+
+ ret = input_register_device(sensehat_joystick->keys_dev);
+ if (ret) {
+ dev_err(&pdev->dev, "Could not register input device.\n");
+ return ret;
+ }
+
+ ret = devm_request_threaded_irq(&pdev->dev, sensehat->i2c_client->irq,
+ NULL, sensehat_joystick_report,
+ IRQF_TRIGGER_RISING | IRQF_ONESHOT,
+ "keys", sensehat);
+
+ if (ret) {
+ dev_err(&pdev->dev, "IRQ request failed.\n");
+ return ret;
+ }
+ return 0;
+}
+
+int sensehat_get_joystick_state(struct sensehat *sensehat)
+{
+ unsigned int reg;
+ int ret = regmap_read(sensehat->regmap, SENSEHAT_KEYS, ®);
+
+ return ret < 0 ? ret : reg;
+}
+
+static struct platform_device_id sensehat_joystick_device_id[] = {
+ { .name = "sensehat-joystick" },
+ {},
+};
+MODULE_DEVICE_TABLE(platform, sensehat_joystick_device_id);
+
+static struct platform_driver sensehat_joystick_driver = {
+ .probe = sensehat_joystick_probe,
+ .driver = {
+ .name = "sensehat-joystick",
+ },
+};
+
+module_platform_driver(sensehat_joystick_driver);
+
+MODULE_DESCRIPTION("Raspberry Pi Sense HAT joystick driver");
+MODULE_AUTHOR("Serge Schneider <serge@raspberrypi.org>");
+MODULE_LICENSE("GPL");
--
2.31.1
next prev parent reply other threads:[~2021-12-10 22:11 UTC|newest]
Thread overview: 15+ messages / expand[flat|nested] mbox.gz Atom feed top
2021-12-10 22:10 [PATCH V5 0/6] Raspberry Pi Sense HAT driver Charles Mirabile
2021-12-10 22:10 ` [PATCH V5 1/6] drivers/mfd: sensehat: Raspberry Pi Sense HAT core driver Charles Mirabile
2021-12-11 20:53 ` Thomas Weißschuh
2021-12-12 11:43 ` Stefan Wahren
2021-12-13 11:49 ` Nicolas Saenz Julienne
2021-12-10 22:10 ` Charles Mirabile [this message]
2021-12-10 23:17 ` [PATCH V5 2/6] drivers/input/joystick: sensehat: Raspberry Pi Sense HAT joystick driver Dmitry Torokhov
2021-12-10 22:10 ` [PATCH V5 3/6] drivers/auxdisplay: sensehat: Raspberry Pi Sense HAT display driver Charles Mirabile
2021-12-11 18:38 ` Miguel Ojeda
2021-12-10 22:10 ` [PATCH V5 4/6] dt-bindings: mfd: sensehat: Add Raspberry Pi Sense HAT schema Charles Mirabile
2021-12-11 19:59 ` Rob Herring
2021-12-13 17:09 ` Rob Herring
2021-12-10 22:10 ` [PATCH V5 5/6] MAINTAINERS: Add sensehat driver authors to MAINTAINERS Charles Mirabile
2021-12-10 22:10 ` [PATCH V5 6/6] DO NOT MERGE: full sensehat device tree overlay for raspberry pi 4 Charles Mirabile
2021-12-13 11:29 ` [PATCH V5 0/6] Raspberry Pi Sense HAT driver Nicolas Saenz Julienne
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20211210221033.912430-3-cmirabil@redhat.com \
--to=cmirabil@redhat.com \
--cc=dmitry.torokhov@gmail.com \
--cc=fedora-rpi@googlegroups.com \
--cc=jsavitz@redhat.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-input@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-rpi-kernel@lists.infradead.org \
--cc=mbrugger@suse.com \
--cc=mguma@redhat.com \
--cc=nsaenzju@redhat.com \
--cc=serge@raspberrypi.org \
--cc=stefan.wahren@i2se.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®