[PATCH v2] staging: media: ipu3: Fix AWB x_start position when rightmost stripe is used

[Kate Hsuan <hpa@redhat.com>]

A not calibrated x_start setting would result in an incorrect AWB location
configuration on a sensor when only the rightmost stripe is used. x_start
should be calibrated by subtracting the stripe offset to set the coordinate
to the correct position on the second stripe.

Signed-off-by: Kate Hsuan <hpa@redhat.com>
---
Correct the patch. The correction should be awb, not awb_fr.
---
 drivers/staging/media/ipu3/ipu3-css-params.c | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/drivers/staging/media/ipu3/ipu3-css-params.c b/drivers/staging/media/ipu3/ipu3-css-params.c
index f84cf11358a8..76ad802d694e 100644
--- a/drivers/staging/media/ipu3/ipu3-css-params.c
+++ b/drivers/staging/media/ipu3/ipu3-css-params.c
@@ -2636,6 +2636,17 @@ int imgu_css_cfg_acc(struct imgu_css *css, unsigned int pipe,
 	    acc->stripe.down_scaled_stripes[1].offset + min_overlap) {
 		/* Enable only for rightmost stripe, disable left */
 		acc->awb.stripes[0].rgbs_thr_b &= ~IPU3_UAPI_AWB_RGBS_THR_B_EN;
+
+		acc->awb.stripes[1].grid.x_start =
+			(acc->awb.stripes[1].grid.x_start -
+			 acc->stripe.down_scaled_stripes[1].offset) &
+			IPU3_UAPI_GRID_START_MASK;
+
+		b_w_log2 = acc->awb.stripes[1].grid.block_width_log2;
+		acc->awb.stripes[1].grid.x_end =
+			imgu_css_grid_end(acc->awb.stripes[1].grid.x_start,
+					  acc->awb.stripes[1].grid.width,
+					  b_w_log2);
 	} else if (acc->awb.config.grid.x_end <=
 		   acc->stripe.bds_out_stripes[0].width - min_overlap) {
 		/* Enable only for leftmost stripe, disable right */
-- 
2.35.1