[PATCH 3/5] serial: fsl_lpuart: Remove custom frame size calculation

["Ilpo Järvinen" <ilpo.jarvinen@linux.intel.com>]

The number of bits can be calculated using tty_get_frame_size(), no
need for the driver to do it on its own.

Signed-off-by: Ilpo Järvinen <ilpo.jarvinen@linux.intel.com>
---
 drivers/tty/serial/fsl_lpuart.c | 10 +++-------
 1 file changed, 3 insertions(+), 7 deletions(-)

diff --git a/drivers/tty/serial/fsl_lpuart.c b/drivers/tty/serial/fsl_lpuart.c
index f6c33cd228c8..926460f1dc08 100644
--- a/drivers/tty/serial/fsl_lpuart.c
+++ b/drivers/tty/serial/fsl_lpuart.c
@@ -1284,23 +1284,19 @@ static inline int lpuart_start_rx_dma(struct lpuart_port *sport)
 	struct dma_slave_config dma_rx_sconfig = {};
 	struct circ_buf *ring = &sport->rx_ring;
 	int ret, nent;
-	int bits, baud;
+	int baud;
 	struct tty_port *port = &sport->port.state->port;
 	struct tty_struct *tty = port->tty;
 	struct ktermios *termios = &tty->termios;
 	struct dma_chan *chan = sport->dma_rx_chan;
 
 	baud = tty_get_baud_rate(tty);
-
-	bits = (termios->c_cflag & CSIZE) == CS7 ? 9 : 10;
-	if (termios->c_cflag & PARENB)
-		bits++;
-
 	/*
 	 * Calculate length of one DMA buffer size to keep latency below
 	 * 10ms at any baud rate.
 	 */
-	sport->rx_dma_rng_buf_len = (DMA_RX_TIMEOUT * baud /  bits / 1000) * 2;
+	sport->rx_dma_rng_buf_len = (DMA_RX_TIMEOUT * baud / tty_get_frame_size(termios->c_cflag) /
+				     1000) * 2;
 	sport->rx_dma_rng_buf_len = (1 << (fls(sport->rx_dma_rng_buf_len) - 1));
 	if (sport->rx_dma_rng_buf_len < 16)
 		sport->rx_dma_rng_buf_len = 16;
-- 
2.30.2