From: Sean Christopherson <seanjc@google.com>
To: Sean Christopherson <seanjc@google.com>,
Paolo Bonzini <pbonzini@redhat.com>
Cc: kvm@vger.kernel.org, linux-kernel@vger.kernel.org,
Suravee Suthikulpanit <suravee.suthikulpanit@amd.com>,
Maxim Levitsky <mlevitsk@redhat.com>,
Li RongQing <lirongqing@baidu.com>
Subject: [PATCH 01/19] KVM: SVM: Process ICR on AVIC IPI delivery failure due to invalid target
Date: Wed, 31 Aug 2022 00:34:48 +0000 [thread overview]
Message-ID: <20220831003506.4117148-2-seanjc@google.com> (raw)
In-Reply-To: <20220831003506.4117148-1-seanjc@google.com>
Emulate ICR writes on AVIC IPI failures due to invalid targets using the
same logic as failures due to invalid types. AVIC acceleration fails if
_any_ of the targets are invalid, and crucially VM-Exits before sending
IPIs to targets that _are_ valid. In logical mode, the destination is a
bitmap, i.e. a single IPI can target multiple logical IDs. Doing nothing
causes KVM to drop IPIs if at least one target is valid and at least one
target is invalid.
Fixes: 18f40c53e10f ("svm: Add VMEXIT handlers for AVIC")
Cc: stable@vger.kernel.org
Signed-off-by: Sean Christopherson <seanjc@google.com>
---
arch/x86/kvm/svm/avic.c | 16 +++++++++-------
1 file changed, 9 insertions(+), 7 deletions(-)
diff --git a/arch/x86/kvm/svm/avic.c b/arch/x86/kvm/svm/avic.c
index 6919dee69f18..b1ade555e8d0 100644
--- a/arch/x86/kvm/svm/avic.c
+++ b/arch/x86/kvm/svm/avic.c
@@ -496,14 +496,18 @@ int avic_incomplete_ipi_interception(struct kvm_vcpu *vcpu)
trace_kvm_avic_incomplete_ipi(vcpu->vcpu_id, icrh, icrl, id, index);
switch (id) {
+ case AVIC_IPI_FAILURE_INVALID_TARGET:
case AVIC_IPI_FAILURE_INVALID_INT_TYPE:
/*
* Emulate IPIs that are not handled by AVIC hardware, which
- * only virtualizes Fixed, Edge-Triggered INTRs. The exit is
- * a trap, e.g. ICR holds the correct value and RIP has been
- * advanced, KVM is responsible only for emulating the IPI.
- * Sadly, hardware may sometimes leave the BUSY flag set, in
- * which case KVM needs to emulate the ICR write as well in
+ * only virtualizes Fixed, Edge-Triggered INTRs, and falls over
+ * if _any_ targets are invalid, e.g. if the logical mode mask
+ * is a superset of running vCPUs.
+ *
+ * The exit is a trap, e.g. ICR holds the correct value and RIP
+ * has been advanced, KVM is responsible only for emulating the
+ * IPI. Sadly, hardware may sometimes leave the BUSY flag set,
+ * in which case KVM needs to emulate the ICR write as well in
* order to clear the BUSY flag.
*/
if (icrl & APIC_ICR_BUSY)
@@ -519,8 +523,6 @@ int avic_incomplete_ipi_interception(struct kvm_vcpu *vcpu)
*/
avic_kick_target_vcpus(vcpu->kvm, apic, icrl, icrh, index);
break;
- case AVIC_IPI_FAILURE_INVALID_TARGET:
- break;
case AVIC_IPI_FAILURE_INVALID_BACKING_PAGE:
WARN_ONCE(1, "Invalid backing page\n");
break;
--
2.37.2.672.g94769d06f0-goog
next prev parent reply other threads:[~2022-08-31 0:37 UTC|newest]
Thread overview: 74+ messages / expand[flat|nested] mbox.gz Atom feed top
2022-08-31 0:34 [PATCH 00/19] KVM: x86: AVIC and local APIC fixes+cleanups Sean Christopherson
2022-08-31 0:34 ` Sean Christopherson [this message]
2022-08-31 9:18 ` [PATCH 01/19] KVM: SVM: Process ICR on AVIC IPI delivery failure due to invalid target Maxim Levitsky
2022-08-31 0:34 ` [PATCH 02/19] KVM: SVM: Don't put/load AVIC when setting virtual APIC mode Sean Christopherson
2022-08-31 9:24 ` Maxim Levitsky
2022-08-31 16:33 ` Sean Christopherson
2022-08-31 0:34 ` [PATCH 03/19] Revert "KVM: SVM: Introduce hybrid-AVIC mode" Sean Christopherson
2022-08-31 5:59 ` Maxim Levitsky
2022-08-31 6:45 ` Maxim Levitsky
2022-08-31 16:29 ` Sean Christopherson
2022-08-31 17:46 ` Maxim Levitsky
2022-08-31 17:58 ` Jim Mattson
2022-08-31 18:01 ` Maxim Levitsky
2022-08-31 19:12 ` Sean Christopherson
2022-09-01 10:25 ` Maxim Levitsky
2022-09-01 11:47 ` Jim Mattson
2022-09-01 13:29 ` Sean Christopherson
2022-09-01 13:53 ` Sean Christopherson
2022-09-01 15:08 ` Sean Christopherson
2022-08-31 16:19 ` Sean Christopherson
2022-08-31 17:47 ` Maxim Levitsky
2022-08-31 0:34 ` [PATCH 04/19] KVM: SVM: Replace "avic_mode" enum with "x2avic_enabled" boolean Sean Christopherson
2022-08-31 9:36 ` Maxim Levitsky
2022-08-31 0:34 ` [PATCH 05/19] KVM: SVM: Compute dest based on sender's x2APIC status for AVIC kick Sean Christopherson
2022-08-31 9:38 ` Maxim Levitsky
2022-09-01 2:56 ` Li,Rongqing
2022-08-31 0:34 ` [PATCH 06/19] KVM: SVM: Get x2APIC logical dest bitmap from ICRH[15:0], not ICHR[31:16] Sean Christopherson
2022-08-31 6:09 ` Maxim Levitsky
2022-08-31 9:43 ` Maxim Levitsky
2022-08-31 16:35 ` Sean Christopherson
2022-08-31 18:18 ` Maxim Levitsky
2022-08-31 0:34 ` [PATCH 07/19] KVM: SVM: Drop buggy and redundant AVIC "single logical dest" check Sean Christopherson
2022-08-31 6:19 ` Maxim Levitsky
2022-08-31 16:37 ` Sean Christopherson
2022-08-31 18:10 ` Maxim Levitsky
2022-08-31 0:34 ` [PATCH 08/19] KVM: SVM: Remove redundant cluster calculation that also creates a shadow Sean Christopherson
2022-08-31 10:19 ` Maxim Levitsky
2022-09-01 20:02 ` Sean Christopherson
2022-08-31 0:34 ` [PATCH 09/19] KVM: SVM: Drop duplicate calcuation of AVIC/x2AVIC "logical index" Sean Christopherson
2022-08-31 0:34 ` [PATCH 10/19] KVM: SVM: Document that vCPU ID == APIC ID in AVIC kick fastpatch Sean Christopherson
2022-08-31 10:22 ` Maxim Levitsky
2022-08-31 16:16 ` Sean Christopherson
2022-08-31 17:49 ` Maxim Levitsky
2022-08-31 0:34 ` [PATCH 11/19] KVM: SVM: Add helper to perform final AVIC "kick" of single vCPU Sean Christopherson
2022-08-31 10:25 ` Maxim Levitsky
2022-08-31 15:08 ` Sean Christopherson
2022-08-31 18:12 ` Maxim Levitsky
2022-08-31 0:34 ` [PATCH 12/19] KVM: x86: Disable APIC logical map if logical ID covers multiple MDAs Sean Christopherson
2022-08-31 13:23 ` Maxim Levitsky
2022-08-31 0:35 ` [PATCH 13/19] KVM: x86: Disable APIC logical map if vCPUs are aliased in logical mode Sean Christopherson
2022-08-31 13:24 ` Maxim Levitsky
2022-08-31 0:35 ` [PATCH 14/19] KVM: x86: Honor architectural behavior for aliased 8-bit APIC IDs Sean Christopherson
2022-08-31 13:37 ` Maxim Levitsky
2022-08-31 16:41 ` Sean Christopherson
2022-08-31 17:51 ` Maxim Levitsky
2022-08-31 0:35 ` [PATCH 15/19] KVM: x86: Explicitly skip optimized logical map setup if vCPU's LDR==0 Sean Christopherson
2022-08-31 13:41 ` Maxim Levitsky
2022-08-31 16:47 ` Sean Christopherson
2022-08-31 0:35 ` [PATCH 16/19] KVM: x86: Explicitly track all possibilities for APIC map's logical modes Sean Christopherson
2022-08-31 13:43 ` Maxim Levitsky
2022-08-31 16:56 ` Sean Christopherson
2022-08-31 17:53 ` Maxim Levitsky
2022-09-16 18:58 ` Sean Christopherson
2022-08-31 18:42 ` Maxim Levitsky
2022-08-31 19:17 ` Sean Christopherson
2022-08-31 0:35 ` [PATCH 17/19] KVM: SVM: Handle multiple logical targets in AVIC kick fastpath Sean Christopherson
2022-08-31 13:57 ` Maxim Levitsky
2022-08-31 18:19 ` Sean Christopherson
2022-08-31 18:25 ` Maxim Levitsky
2022-08-31 0:35 ` [PATCH 18/19] KVM: SVM: Ignore writes to Remote Read Data on AVIC write traps Sean Christopherson
2022-08-31 10:40 ` Maxim Levitsky
2022-08-31 0:35 ` [PATCH 19/19] Revert "KVM: SVM: Do not throw warning when calling avic_vcpu_load on a running vcpu" Sean Christopherson
2022-08-31 6:07 ` Maxim Levitsky
2022-08-31 7:03 ` Maxim Levitsky
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20220831003506.4117148-2-seanjc@google.com \
--to=seanjc@google.com \
--cc=kvm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=lirongqing@baidu.com \
--cc=mlevitsk@redhat.com \
--cc=pbonzini@redhat.com \
--cc=suravee.suthikulpanit@amd.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®