From: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
To: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Cc: Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>,
Rob Herring <robh+dt@kernel.org>,
devicetree@vger.kernel.org,
Srinivas Kandagatla <srinivas.kandagatla@linaro.org>,
linux-arm-msm@vger.kernel.org, Andy Gross <agross@kernel.org>,
Bjorn Andersson <andersson@kernel.org>,
Linus Walleij <linus.walleij@linaro.org>,
Konrad Dybcio <konrad.dybcio@somainline.org>,
linux-kernel@vger.kernel.org, linux-gpio@vger.kernel.org
Subject: Re: [PATCH 08/12] dt-bindings: pinctrl: qcom,sm8250-lpass-lpi: add bias-bus-hold and input-enable
Date: Fri, 23 Sep 2022 11:31:31 +0200 [thread overview]
Message-ID: <20220923093131.5fb5co5i3f4eybcs@krzk-bin> (raw)
In-Reply-To: <20220922195651.345369-9-krzysztof.kozlowski@linaro.org>
On Thu, 22 Sep 2022 21:56:47 +0200, Krzysztof Kozlowski wrote:
> The existing SC7280 LPASS pin controller nodes use bias-bus-hold and
> input-enable, so allow them. Squash also blank lines for readability.
>
> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
> ---
> .../bindings/pinctrl/qcom,sm8250-lpass-lpi-pinctrl.yaml | 6 ++----
> 1 file changed, 2 insertions(+), 4 deletions(-)
>
Running 'make dtbs_check' with the schema in this patch gives the
following warnings. Consider if they are expected or the schema is
incorrect. These may not be new warnings.
Note that it is not yet a requirement to have 0 warnings for dtbs_check.
This will change in the future.
Full log is available here: https://patchwork.ozlabs.org/patch/1681325
pinctrl@33c0000: 'dmic01-active-pins', 'dmic01-sleep-pins', 'rx_swr-active-pins', 'tx_swr-active-pins', 'tx_swr-sleep-pins', 'wsa-swr-active-pins', 'wsa-swr-sleep-pins' do not match any of the regexes: '-state$', 'pinctrl-[0-9]+'
arch/arm64/boot/dts/qcom/qrb5165-rb5.dtb
arch/arm64/boot/dts/qcom/sm8250-hdk.dtb
arch/arm64/boot/dts/qcom/sm8250-mtp.dtb
arch/arm64/boot/dts/qcom/sm8250-sony-xperia-edo-pdx203.dtb
arch/arm64/boot/dts/qcom/sm8250-sony-xperia-edo-pdx206.dtb
next prev parent reply other threads:[~2022-09-23 9:32 UTC|newest]
Thread overview: 26+ messages / expand[flat|nested] mbox.gz Atom feed top
2022-09-22 19:56 [PATCH 00/12] pinctrl/arm64: qcom: continued - fix Qualcomm LPASS pinctrl schema warnings Krzysztof Kozlowski
2022-09-22 19:56 ` [PATCH 01/12] dt-bindings: pinctrl: qcom,sc8280xp-lpass-lpi: fix gpio pattern Krzysztof Kozlowski
2022-09-26 20:33 ` Rob Herring
2022-09-26 20:40 ` Rob Herring
2022-09-27 11:34 ` Krzysztof Kozlowski
2022-09-22 19:56 ` [PATCH 02/12] dt-bindings: pinctrl: qcom,sm8450-lpass-lpi: " Krzysztof Kozlowski
2022-09-26 20:41 ` Rob Herring
2022-09-22 19:56 ` [PATCH 03/12] dt-bindings: pinctrl: qcom,sc7280-lpass-lpi: fix matching pin config Krzysztof Kozlowski
2022-09-26 20:37 ` Rob Herring
2022-09-22 19:56 ` [PATCH 04/12] dt-bindings: pinctrl: qcom,sc8280xp-lpass-lpi: " Krzysztof Kozlowski
2022-09-26 20:37 ` Rob Herring
2022-09-22 19:56 ` [PATCH 05/12] dt-bindings: pinctrl: qcom,sm8250-lpass-lpi: " Krzysztof Kozlowski
2022-09-26 20:38 ` Rob Herring
2022-09-22 19:56 ` [PATCH 06/12] dt-bindings: pinctrl: qcom,sm8450-lpass-lpi: " Krzysztof Kozlowski
2022-09-26 20:38 ` Rob Herring
2022-09-22 19:56 ` [PATCH 07/12] dt-bindings: pinctrl: qcom,sc7280-lpass-lpi: add bias-bus-hold Krzysztof Kozlowski
2022-09-26 20:38 ` Rob Herring
2022-09-22 19:56 ` [PATCH 08/12] dt-bindings: pinctrl: qcom,sm8250-lpass-lpi: add bias-bus-hold and input-enable Krzysztof Kozlowski
2022-09-23 9:31 ` Krzysztof Kozlowski [this message]
2022-09-23 10:31 ` Krzysztof Kozlowski
2022-09-26 20:41 ` Rob Herring
2022-09-22 19:56 ` [PATCH 09/12] arm64: dts: qcom: sc7280: drop clock-cells from LPASS TLMM Krzysztof Kozlowski
2022-09-22 19:56 ` [PATCH 10/12] arm64: dts: qcom: sc7280: align LPASS pin configuration with DT schema Krzysztof Kozlowski
2022-09-22 19:56 ` [PATCH 11/12] arm64: dts: qcom: sm8250: correct LPASS pin pull down Krzysztof Kozlowski
2022-09-22 19:56 ` [PATCH 12/12] arm64: dts: qcom: sm8250: align LPASS pin configuration with DT schema Krzysztof Kozlowski
2022-10-03 21:59 ` [PATCH 00/12] pinctrl/arm64: qcom: continued - fix Qualcomm LPASS pinctrl schema warnings Linus Walleij
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20220923093131.5fb5co5i3f4eybcs@krzk-bin \
--to=krzysztof.kozlowski@linaro.org \
--cc=agross@kernel.org \
--cc=andersson@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=konrad.dybcio@somainline.org \
--cc=krzysztof.kozlowski+dt@linaro.org \
--cc=linus.walleij@linaro.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=robh+dt@kernel.org \
--cc=srinivas.kandagatla@linaro.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®