[PATCH v2 1/2] dt-bindings: mtd: jedec, spi-nor: Add DT property to avoid setting SRWD bit in status register

[Amit Kumar Mahapatra <amit.kumar-mahapatra@amd.com>]

If the WP signal of the flash device is not connected and the software sets
the status register write disable (SRWD) bit in the status register then
thestatus register permanently becomes read-only. To avoid this added a new
boolean DT property "broken-wp". If WP signal is not connected, then this
property should be set in the DT to avoid setting the SRWD during status
register write operation.

Signed-off-by: Amit Kumar Mahapatra <amit.kumar-mahapatra@amd.com>
Reviewed-by: Conor Dooley <conor.dooley@microchip.com>
---
 .../devicetree/bindings/mtd/jedec,spi-nor.yaml    | 15 +++++++++++++++
 1 file changed, 15 insertions(+)

diff --git a/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml b/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml
index 89959e5c47ba..10a6df752f6f 100644
--- a/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml
+++ b/Documentation/devicetree/bindings/mtd/jedec,spi-nor.yaml
@@ -70,6 +70,21 @@ properties:
       be used on such systems, to denote the absence of a reliable reset
       mechanism.
 
+  broken-wp:
+    type: boolean
+    description:
+      The status register write disable (SRWD) bit in status register, combined
+      with the WP signal, provides hardware data protection for the device. When
+      the SRWD bit is set to 1, and the WP signal is either driven LOW or hard
+      strapped to LOW, the status register nonvolatile bits become read-only and
+      the WRITE STATUS REGISTER operation will not execute. The only way to exit
+      this hardware-protected mode is to drive WP HIGH. If the WP signal of the
+      flash device is not connected then status register permanently becomes
+      read-only as the SRWD bit cannot be reset. This boolean flag can be used
+      on systems in which WP signal is not connected, to avoid setting the SRWD
+      bit while writing the status register. If the WP signal is hard strapped
+      to LOW then it is not broken as it can be a valid use case.
+
   reset-gpios:
     description:
       A GPIO line connected to the RESET (active low) signal of the device.
-- 
2.17.1