From: Andrew Davis <afd@ti.com>
To: Nishanth Menon <nm@ti.com>, Vignesh Raghavendra <vigneshr@ti.com>,
Tero Kristo <kristo@kernel.org>, Rob Herring <robh+dt@kernel.org>,
Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>,
Conor Dooley <conor+dt@kernel.org>
Cc: <linux-arm-kernel@lists.infradead.org>,
<devicetree@vger.kernel.org>, <linux-kernel@vger.kernel.org>,
Andrew Davis <afd@ti.com>
Subject: [PATCH 2/2] arm64: dts: ti: k3-am64: Enable SDHCI nodes at the board level
Date: Fri, 17 Nov 2023 10:33:39 -0600 [thread overview]
Message-ID: <20231117163339.89952-2-afd@ti.com> (raw)
In-Reply-To: <20231117163339.89952-1-afd@ti.com>
SDHCI nodes defined in the top-level AM64 SoC dtsi files are incomplete
and will not be functional unless they are extended.
As the attached SD/eMMC is only known about at the board integration level,
these nodes should only be enabled when provided with this information.
Disable the SDHCI nodes in the dtsi files and only enable the ones that
are actually pinned out on a given board.
Signed-off-by: Andrew Davis <afd@ti.com>
---
arch/arm64/boot/dts/ti/k3-am64-main.dtsi | 2 ++
arch/arm64/boot/dts/ti/k3-am64-phycore-som.dtsi | 1 +
arch/arm64/boot/dts/ti/k3-am642-evm.dts | 6 ++++--
arch/arm64/boot/dts/ti/k3-am642-phyboard-electra-rdk.dts | 1 +
arch/arm64/boot/dts/ti/k3-am642-sk.dts | 4 +++-
arch/arm64/boot/dts/ti/k3-am642-tqma64xxl-mbax4xxl.dts | 1 -
arch/arm64/boot/dts/ti/k3-am642-tqma64xxl.dtsi | 1 +
7 files changed, 12 insertions(+), 4 deletions(-)
diff --git a/arch/arm64/boot/dts/ti/k3-am64-main.dtsi b/arch/arm64/boot/dts/ti/k3-am64-main.dtsi
index 0be642bc1b86d..c3300c36fdbcb 100644
--- a/arch/arm64/boot/dts/ti/k3-am64-main.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-am64-main.dtsi
@@ -623,6 +623,7 @@ sdhci0: mmc@fa10000 {
ti,otap-del-sel-mmc-hs = <0x0>;
ti,otap-del-sel-ddr52 = <0x6>;
ti,otap-del-sel-hs200 = <0x7>;
+ status = "disabled";
};
sdhci1: mmc@fa00000 {
@@ -641,6 +642,7 @@ sdhci1: mmc@fa00000 {
ti,otap-del-sel-sdr104 = <0x6>;
ti,otap-del-sel-ddr50 = <0x9>;
ti,clkbuf-sel = <0x7>;
+ status = "disabled";
};
cpsw3g: ethernet@8000000 {
diff --git a/arch/arm64/boot/dts/ti/k3-am64-phycore-som.dtsi b/arch/arm64/boot/dts/ti/k3-am64-phycore-som.dtsi
index f87f09d83c956..b8f844f667afc 100644
--- a/arch/arm64/boot/dts/ti/k3-am64-phycore-som.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-am64-phycore-som.dtsi
@@ -211,6 +211,7 @@ flash@0 {
};
&sdhci0 {
+ status = "okay";
bus-width = <8>;
non-removable;
ti,driver-strength-ohm = <50>;
diff --git a/arch/arm64/boot/dts/ti/k3-am642-evm.dts b/arch/arm64/boot/dts/ti/k3-am642-evm.dts
index 4dba18941015d..256606be56fef 100644
--- a/arch/arm64/boot/dts/ti/k3-am642-evm.dts
+++ b/arch/arm64/boot/dts/ti/k3-am642-evm.dts
@@ -487,17 +487,19 @@ eeprom@0 {
};
};
+/* eMMC */
&sdhci0 {
- /* emmc */
+ status = "okay";
bus-width = <8>;
non-removable;
ti,driver-strength-ohm = <50>;
disable-wp;
};
+/* SD/MMC */
&sdhci1 {
- /* SD/MMC */
bootph-all;
+ status = "okay";
vmmc-supply = <&vdd_mmc1>;
pinctrl-names = "default";
bus-width = <4>;
diff --git a/arch/arm64/boot/dts/ti/k3-am642-phyboard-electra-rdk.dts b/arch/arm64/boot/dts/ti/k3-am642-phyboard-electra-rdk.dts
index 9175e96842d82..53b64e55413f9 100644
--- a/arch/arm64/boot/dts/ti/k3-am642-phyboard-electra-rdk.dts
+++ b/arch/arm64/boot/dts/ti/k3-am642-phyboard-electra-rdk.dts
@@ -264,6 +264,7 @@ &main_uart1 {
};
&sdhci1 {
+ status = "okay";
vmmc-supply = <&vcc_3v3_mmc>;
pinctrl-names = "default";
pinctrl-0 = <&main_mmc1_pins_default>;
diff --git a/arch/arm64/boot/dts/ti/k3-am642-sk.dts b/arch/arm64/boot/dts/ti/k3-am642-sk.dts
index f29c8a9b59ba7..bffbd234f715a 100644
--- a/arch/arm64/boot/dts/ti/k3-am642-sk.dts
+++ b/arch/arm64/boot/dts/ti/k3-am642-sk.dts
@@ -439,6 +439,7 @@ &mcu_gpio0 {
};
&sdhci0 {
+ status = "okay";
vmmc-supply = <&wlan_en>;
bus-width = <4>;
non-removable;
@@ -458,9 +459,10 @@ wlcore: wlcore@2 {
};
};
+/* SD/MMC */
&sdhci1 {
- /* SD/MMC */
bootph-all;
+ status = "okay";
vmmc-supply = <&vdd_mmc1>;
pinctrl-names = "default";
bus-width = <4>;
diff --git a/arch/arm64/boot/dts/ti/k3-am642-tqma64xxl-mbax4xxl.dts b/arch/arm64/boot/dts/ti/k3-am642-tqma64xxl-mbax4xxl.dts
index d95d80076a427..55102d35cecc1 100644
--- a/arch/arm64/boot/dts/ti/k3-am642-tqma64xxl-mbax4xxl.dts
+++ b/arch/arm64/boot/dts/ti/k3-am642-tqma64xxl-mbax4xxl.dts
@@ -425,7 +425,6 @@ &sdhci1 {
ti,driver-strength-ohm = <50>;
ti,fails-without-test-cd;
/* Enabled by overlay */
- status = "disabled";
};
&tscadc0 {
diff --git a/arch/arm64/boot/dts/ti/k3-am642-tqma64xxl.dtsi b/arch/arm64/boot/dts/ti/k3-am642-tqma64xxl.dtsi
index d82d4a98306a7..6c785eff7d2ff 100644
--- a/arch/arm64/boot/dts/ti/k3-am642-tqma64xxl.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-am642-tqma64xxl.dtsi
@@ -219,6 +219,7 @@ partitions {
};
&sdhci0 {
+ status = "okay";
non-removable;
disable-wp;
no-sdio;
--
2.39.2
next prev parent reply other threads:[~2023-11-17 16:33 UTC|newest]
Thread overview: 3+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-11-17 16:33 [PATCH 1/2] arm64: dts: ti: k3-am65: " Andrew Davis
2023-11-17 16:33 ` Andrew Davis [this message]
2023-12-04 21:13 ` Nishanth Menon
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20231117163339.89952-2-afd@ti.com \
--to=afd@ti.com \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=kristo@kernel.org \
--cc=krzysztof.kozlowski+dt@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=nm@ti.com \
--cc=robh+dt@kernel.org \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®