[PATCH v6 1/2] arm64: dts: rockchip: rk3399-puma-haikou: add rs485 support on uart2

[Farouk Bouabid <farouk.bouabid@theobroma-systems.com>]

A hardware switch can set the rs485 transceiver into half or full duplex
mode.

Switching to the half-duplex mode requires the user to enable em485 on
uart5 using ioctl, DE/RE are both connected to GPIO2_C3 which is the
RTS signal for uart0. Implement GPIO2_C3 as rts-gpios with RTS_ON_SEND
option enabled (default) so that driver mode gets enabled while sending
(RTS high) and receiver mode gets enabled while not sending (RTS low).

In full-duplex mode (em485 is disabled), DE is connected to GPIO2_C3 and
RE is grounded (enabled). Since GPIO2_C3 is implemented as rts-gpios, the
driver mode gets enabled whenever we want to send something and RE is not
affected (always enabled) in this case by the state of RTS.

Signed-off-by: Farouk Bouabid <farouk.bouabid@theobroma-systems.com>
---
 arch/arm64/boot/dts/rockchip/rk3399-puma-haikou.dts | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/rockchip/rk3399-puma-haikou.dts b/arch/arm64/boot/dts/rockchip/rk3399-puma-haikou.dts
index 18a98c4648ea..2c3984a880af 100644
--- a/arch/arm64/boot/dts/rockchip/rk3399-puma-haikou.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3399-puma-haikou.dts
@@ -273,11 +273,12 @@ &u2phy0_host {
 
 &uart0 {
 	pinctrl-names = "default";
-	pinctrl-0 = <&uart0_xfer &uart0_cts &uart0_rts>;
+	pinctrl-0 = <&uart0_xfer>;
 	status = "okay";
 };
 
 &uart2 {
+	rts-gpios = <&gpio2 RK_PC3 GPIO_ACTIVE_HIGH>;
 	status = "okay";
 };
 

-- 
2.34.1