From: Vineeth Karumanchi <vineeth.karumanchi@amd.com>
To: <nicolas.ferre@microchip.com>, <claudiu.beznea@tuxon.dev>,
<davem@davemloft.net>, <edumazet@google.com>, <kuba@kernel.org>,
<pabeni@redhat.com>, <robh+dt@kernel.org>,
<krzysztof.kozlowski+dt@linaro.org>, <conor+dt@kernel.org>,
<linux@armlinux.org.uk>, <vadim.fedorenko@linux.dev>,
<andrew@lunn.ch>
Cc: <vineeth.karumanchi@amd.com>, <netdev@vger.kernel.org>,
<devicetree@vger.kernel.org>, <linux-kernel@vger.kernel.org>,
<git@amd.com>
Subject: [PATCH net-next v4 3/4] net: macb: Add ARP support to WOL
Date: Mon, 10 Jun 2024 11:09:35 +0530 [thread overview]
Message-ID: <20240610053936.622237-4-vineeth.karumanchi@amd.com> (raw)
In-Reply-To: <20240610053936.622237-1-vineeth.karumanchi@amd.com>
Extend wake-on LAN support with an ARP packet.
Currently, if PHY supports WOL, ethtool ignores the modes supported
by MACB. This change extends the WOL modes with MACB supported modes.
Advertise wake-on LAN supported modes by default without relying on
dt node. By default, wake-on LAN will be in disabled state.
Using ethtool, users can enable/disable or choose packet types.
For wake-on LAN via ARP, ensure the IP address is assigned and
report an error otherwise.
Co-developed-by: Harini Katakam <harini.katakam@amd.com>
Signed-off-by: Harini Katakam <harini.katakam@amd.com>
Signed-off-by: Vineeth Karumanchi <vineeth.karumanchi@amd.com>
---
Changes in v4:
- Extend MACB WOL supported modes to the PHY supported WOL modes.
---
drivers/net/ethernet/cadence/macb.h | 1 +
drivers/net/ethernet/cadence/macb_main.c | 56 +++++++++++++-----------
2 files changed, 31 insertions(+), 26 deletions(-)
diff --git a/drivers/net/ethernet/cadence/macb.h b/drivers/net/ethernet/cadence/macb.h
index 50cd35ef21ad..122663ff7834 100644
--- a/drivers/net/ethernet/cadence/macb.h
+++ b/drivers/net/ethernet/cadence/macb.h
@@ -1306,6 +1306,7 @@ struct macb {
unsigned int jumbo_max_len;
u32 wol;
+ u32 wolopts;
/* holds value of rx watermark value for pbuf_rxcutthru register */
u32 rx_watermark;
diff --git a/drivers/net/ethernet/cadence/macb_main.c b/drivers/net/ethernet/cadence/macb_main.c
index 4007b291526f..1844fe719e78 100644
--- a/drivers/net/ethernet/cadence/macb_main.c
+++ b/drivers/net/ethernet/cadence/macb_main.c
@@ -38,6 +38,7 @@
#include <linux/ptp_classify.h>
#include <linux/reset.h>
#include <linux/firmware/xlnx-zynqmp.h>
+#include <linux/inetdevice.h>
#include "macb.h"
/* This structure is only used for MACB on SiFive FU540 devices */
@@ -84,8 +85,7 @@ struct sifive_fu540_macb_mgmt {
#define GEM_MTU_MIN_SIZE ETH_MIN_MTU
#define MACB_NETIF_LSO NETIF_F_TSO
-#define MACB_WOL_HAS_MAGIC_PACKET (0x1 << 0)
-#define MACB_WOL_ENABLED (0x1 << 1)
+#define MACB_WOL_ENABLED (0x1 << 0)
#define HS_SPEED_10000M 4
#define MACB_SERDES_RATE_10G 1
@@ -3278,13 +3278,11 @@ static void macb_get_wol(struct net_device *netdev, struct ethtool_wolinfo *wol)
{
struct macb *bp = netdev_priv(netdev);
- if (bp->wol & MACB_WOL_HAS_MAGIC_PACKET) {
- phylink_ethtool_get_wol(bp->phylink, wol);
- wol->supported |= WAKE_MAGIC;
+ phylink_ethtool_get_wol(bp->phylink, wol);
+ wol->supported |= (WAKE_MAGIC | WAKE_ARP);
- if (bp->wol & MACB_WOL_ENABLED)
- wol->wolopts |= WAKE_MAGIC;
- }
+ /* Add macb wolopts to phy wolopts */
+ wol->wolopts |= bp->wolopts;
}
static int macb_set_wol(struct net_device *netdev, struct ethtool_wolinfo *wol)
@@ -3294,22 +3292,15 @@ static int macb_set_wol(struct net_device *netdev, struct ethtool_wolinfo *wol)
/* Pass the order to phylink layer */
ret = phylink_ethtool_set_wol(bp->phylink, wol);
- /* Don't manage WoL on MAC if handled by the PHY
- * or if there's a failure in talking to the PHY
- */
- if (!ret || ret != -EOPNOTSUPP)
+ /* Don't manage WoL on MAC if there's a failure in talking to the PHY */
+ if (!!ret && ret != -EOPNOTSUPP)
return ret;
- if (!(bp->wol & MACB_WOL_HAS_MAGIC_PACKET) ||
- (wol->wolopts & ~WAKE_MAGIC))
- return -EOPNOTSUPP;
-
- if (wol->wolopts & WAKE_MAGIC)
- bp->wol |= MACB_WOL_ENABLED;
- else
- bp->wol &= ~MACB_WOL_ENABLED;
+ bp->wolopts = (wol->wolopts & WAKE_MAGIC) ? WAKE_MAGIC : 0;
+ bp->wolopts |= (wol->wolopts & WAKE_ARP) ? WAKE_ARP : 0;
+ bp->wol = (wol->wolopts) ? MACB_WOL_ENABLED : 0;
- device_set_wakeup_enable(&bp->pdev->dev, bp->wol & MACB_WOL_ENABLED);
+ device_set_wakeup_enable(&bp->pdev->dev, bp->wol);
return 0;
}
@@ -5086,9 +5077,7 @@ static int macb_probe(struct platform_device *pdev)
bp->max_tx_length = GEM_MAX_TX_LEN;
bp->wol = 0;
- if (of_property_read_bool(np, "magic-packet"))
- bp->wol |= MACB_WOL_HAS_MAGIC_PACKET;
- device_set_wakeup_capable(&pdev->dev, bp->wol & MACB_WOL_HAS_MAGIC_PACKET);
+ device_set_wakeup_capable(&pdev->dev, 1);
bp->usrio = macb_config->usrio;
@@ -5245,6 +5234,7 @@ static int __maybe_unused macb_suspend(struct device *dev)
struct net_device *netdev = dev_get_drvdata(dev);
struct macb *bp = netdev_priv(netdev);
struct macb_queue *queue;
+ struct in_ifaddr *ifa;
unsigned long flags;
unsigned int q;
int err;
@@ -5257,6 +5247,12 @@ static int __maybe_unused macb_suspend(struct device *dev)
return 0;
if (bp->wol & MACB_WOL_ENABLED) {
+ /* Check for IP address in WOL ARP mode */
+ ifa = rcu_dereference(__in_dev_get_rcu(bp->dev)->ifa_list);
+ if ((bp->wolopts & WAKE_ARP) && !ifa) {
+ netdev_err(netdev, "IP address not assigned\n");
+ return -EOPNOTSUPP;
+ }
spin_lock_irqsave(&bp->lock, flags);
/* Disable Tx and Rx engines before disabling the queues,
@@ -5290,6 +5286,14 @@ static int __maybe_unused macb_suspend(struct device *dev)
macb_writel(bp, TSR, -1);
macb_writel(bp, RSR, -1);
+ tmp = (bp->wolopts & WAKE_MAGIC) ? MACB_BIT(MAG) : 0;
+ if (bp->wolopts & WAKE_ARP) {
+ tmp |= MACB_BIT(ARP);
+ /* write IP address into register */
+ tmp |= MACB_BFEXT(IP,
+ (__force u32)(cpu_to_be32p((uint32_t *)&ifa->ifa_local)));
+ }
+
/* Change interrupt handler and
* Enable WoL IRQ on queue 0
*/
@@ -5305,7 +5309,7 @@ static int __maybe_unused macb_suspend(struct device *dev)
return err;
}
queue_writel(bp->queues, IER, GEM_BIT(WOL));
- gem_writel(bp, WOL, MACB_BIT(MAG));
+ gem_writel(bp, WOL, tmp);
} else {
err = devm_request_irq(dev, bp->queues[0].irq, macb_wol_interrupt,
IRQF_SHARED, netdev->name, bp->queues);
@@ -5317,7 +5321,7 @@ static int __maybe_unused macb_suspend(struct device *dev)
return err;
}
queue_writel(bp->queues, IER, MACB_BIT(WOL));
- macb_writel(bp, WOL, MACB_BIT(MAG));
+ macb_writel(bp, WOL, tmp);
}
spin_unlock_irqrestore(&bp->lock, flags);
--
2.34.1
next prev parent reply other threads:[~2024-06-10 5:40 UTC|newest]
Thread overview: 9+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-06-10 5:39 [PATCH net-next v4 0/4] net: macb: WOL enhancements Vineeth Karumanchi
2024-06-10 5:39 ` [PATCH net-next v4 1/4] net: macb: queue tie-off or disable during WOL suspend Vineeth Karumanchi
2024-06-10 5:39 ` [PATCH net-next v4 2/4] net: macb: Enable queue disable Vineeth Karumanchi
2024-06-10 5:39 ` Vineeth Karumanchi [this message]
2024-06-10 12:46 ` [PATCH net-next v4 3/4] net: macb: Add ARP support to WOL Andrew Lunn
2024-06-11 6:05 ` Vineeth Karumanchi
2024-06-11 12:57 ` Andrew Lunn
2024-06-10 5:39 ` [PATCH net-next v4 4/4] dt-bindings: net: cdns,macb: Deprecate magic-packet property Vineeth Karumanchi
2024-06-10 12:46 ` Krzysztof Kozlowski
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20240610053936.622237-4-vineeth.karumanchi@amd.com \
--to=vineeth.karumanchi@amd.com \
--cc=andrew@lunn.ch \
--cc=claudiu.beznea@tuxon.dev \
--cc=conor+dt@kernel.org \
--cc=davem@davemloft.net \
--cc=devicetree@vger.kernel.org \
--cc=edumazet@google.com \
--cc=git@amd.com \
--cc=krzysztof.kozlowski+dt@linaro.org \
--cc=kuba@kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux@armlinux.org.uk \
--cc=netdev@vger.kernel.org \
--cc=nicolas.ferre@microchip.com \
--cc=pabeni@redhat.com \
--cc=robh+dt@kernel.org \
--cc=vadim.fedorenko@linux.dev \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®