From: Delphine CC Chiu <Delphine_CC_Chiu@wiwynn.com>
To: patrick@stwcx.xyz, Rob Herring <robh@kernel.org>,
Krzysztof Kozlowski <krzk+dt@kernel.org>,
Conor Dooley <conor+dt@kernel.org>, Joel Stanley <joel@jms.id.au>,
Andrew Jeffery <andrew@codeconstruct.com.au>
Cc: Delphine CC Chiu <Delphine_CC_Chiu@wiwynn.com>,
devicetree@vger.kernel.org, linux-arm-kernel@lists.infradead.org,
linux-aspeed@lists.ozlabs.org, linux-kernel@vger.kernel.org
Subject: [PATCH v10 27/27] ARM: dts: aspeed: yosemite4: Adjust ioexp bus and remove mctp driver
Date: Fri, 19 Jul 2024 13:58:56 +0800 [thread overview]
Message-ID: <20240719055859.4166887-28-Delphine_CC_Chiu@wiwynn.com> (raw)
In-Reply-To: <20240719055859.4166887-1-Delphine_CC_Chiu@wiwynn.com>
Adjust CPLD io expender for PVT stage.
Add GPIO name for GPIOO7.
Only binding MCTP driver on the down-stream port of the mux.
Remove unnecessary driver binding since there's no MCTP device before the mux.
Signed-off-by: Delphine CC Chiu <Delphine_CC_Chiu@wiwynn.com>
---
.../aspeed/aspeed-bmc-facebook-yosemite4.dts | 59 +++++++++----------
1 file changed, 29 insertions(+), 30 deletions(-)
diff --git a/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite4.dts b/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite4.dts
index 7ad080e3f432..1edde3923ae7 100644
--- a/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite4.dts
+++ b/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite4.dts
@@ -1156,6 +1156,34 @@ rtc@6f {
compatible = "nuvoton,nct3018y";
reg = <0x6f>;
};
+
+ gpio@20 {
+ compatible = "nxp,pca9506";
+ reg = <0x20>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ };
+
+ gpio@21 {
+ compatible = "nxp,pca9506";
+ reg = <0x21>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ };
+
+ gpio@22 {
+ compatible = "nxp,pca9506";
+ reg = <0x22>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ };
+
+ gpio@23 {
+ compatible = "nxp,pca9506";
+ reg = <0x23>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ };
};
imux35: i2c@1 {
@@ -1188,34 +1216,6 @@ ipmb@10 {
reg = <(0x10 | I2C_OWN_SLAVE_ADDRESS)>;
i2c-protocol;
};
-
- gpio@20 {
- compatible = "nxp,pca9506";
- reg = <0x20>;
- gpio-controller;
- #gpio-cells = <2>;
- };
-
- gpio@21 {
- compatible = "nxp,pca9506";
- reg = <0x21>;
- gpio-controller;
- #gpio-cells = <2>;
- };
-
- gpio@22 {
- compatible = "nxp,pca9506";
- reg = <0x22>;
- gpio-controller;
- #gpio-cells = <2>;
- };
-
- gpio@23 {
- compatible = "nxp,pca9506";
- reg = <0x23>;
- gpio-controller;
- #gpio-cells = <2>;
- };
};
&i2c14 {
@@ -1470,7 +1470,6 @@ adc@35 {
&i2c15 {
status = "okay";
- mctp-controller;
multi-master;
bus-frequency = <400000>;
i2c-clk-high-min-percent = <40>;
@@ -1680,7 +1679,7 @@ &pinctrl_gpio3_unbiased &pinctrl_gpio4_unbiased
"FM-BMC-READY-R2","RST-SMB-NIC0-R-N","","",
/*O0-O7*/ "AC-ON-OFF-BTN-CPLD-SLOT8-N","RST-SMB-NIC1-R-N",
"RST-SMB-NIC2-R-N","RST-SMB-NIC3-R-N",
- "","","","",
+ "","","","FM_BMC_SLED_CYCLE_R",
/*P0-P7*/ "ALT-SMB-BMC-CPLD1-N","'BTN-BMC-R2-N",
"EN-P3V-BAT-SCALED-R","PWRGD-P5V-USB-BMC",
"FM-BMC-RTCRST-R","RST-USB-HUB-R-N",
--
2.25.1
prev parent reply other threads:[~2024-07-19 6:01 UTC|newest]
Thread overview: 28+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-07-19 5:58 [PATCH v10 00/27] Add i2c-mux and eeprom devices for Meta Yosemite 4 Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 01/27] ARM: dts: aspeed: yosemite4: Revise i2c-mux devices Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 02/27] ARM: dts: aspeed: yosemite4: Enable adc15 Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 03/27] ARM: dts: aspeed: yosemite4: Enable spi-gpio setting Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 04/27] ARM: dts: aspeed: yosemite4: Enable watchdog2 Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 05/27] ARM: dts: aspeed: yosemite4: Revise quad mode to dual mode Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 06/27] ARM: dts: aspeed: yosemite4: Revise power sensor adm1281 for schematic change Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 07/27] ARM: dts: aspeed: yosemite4: Add gpio pca9506 Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 08/27] ARM: dts: aspeed: yosemite4: Remove space for adm1272 compatible Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 09/27] ARM: dts: aspeed: yosemite4: Enable interrupt setting for pca9555 Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 10/27] ARM: dts: aspeed: yosemite4: Add power sensor for power module reading Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 11/27] ARM: dts: aspeed: yosemite4: Add eeprom for yosemite4 use Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 12/27] ARM: dts: aspeed: yosemite4: Remove temperature sensor for yosemite4 schematic change Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 13/27] ARM: dts: aspeed: yosemite4: Revise adc128d818 adc mode " Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 14/27] ARM: dts: aspeed: yosemite4: Revise ina233 config " Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 15/27] ARM: dts: aspeed: yosemite4: Remove idle state setting for yosemite4 NIC connection Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 16/27] ARM: dts: aspeed: yosemite4: Initialize bmc gpio state Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 17/27] ARM: dts: aspeed: yosemite4: Revise mx31790 fan tach config Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 18/27] ARM: dts: aspeed: yosemite4: add mctp config for NIC Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 19/27] ARM: dts: aspeed: yosemite4: support mux to cpld Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 20/27] ARM: dts: aspeed: yosemite4: support medusa board adc sensors Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 21/27] ARM: dts: aspeed: yosemite4: support NIC eeprom Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 22/27] ARM: dts: aspeed: yosemite4: Revise i2c duty-cycle Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 23/27] ARM: dts: aspeed: yosemite4: add fan led config Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 24/27] ARM: dts: aspeed: yosemite4: add XDP710 Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 25/27] ARM: dts: aspeed: yosemite4: add RTQ6056 support Delphine CC Chiu
2024-07-19 5:58 ` [PATCH v10 26/27] ARM: dts: aspeed: yosemite4: add MP5990 support Delphine CC Chiu
2024-07-19 5:58 ` Delphine CC Chiu [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20240719055859.4166887-28-Delphine_CC_Chiu@wiwynn.com \
--to=delphine_cc_chiu@wiwynn.com \
--cc=andrew@codeconstruct.com.au \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=joel@jms.id.au \
--cc=krzk+dt@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-aspeed@lists.ozlabs.org \
--cc=linux-kernel@vger.kernel.org \
--cc=patrick@stwcx.xyz \
--cc=robh@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®