From: Svyatoslav Ryhel <clamor95@gmail.com>
To: Rob Herring <robh+dt@kernel.org>,
Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>,
Conor Dooley <conor+dt@kernel.org>,
Thierry Reding <thierry.reding@gmail.com>,
Jonathan Hunter <jonathanh@nvidia.com>,
Svyatoslav Ryhel <clamor95@gmail.com>
Cc: devicetree@vger.kernel.org, linux-tegra@vger.kernel.org,
linux-kernel@vger.kernel.org
Subject: [PATCH v1 08/11] ARM: nvidia: tf701t: bind WIFI SDIO and EMMC
Date: Tue, 6 Aug 2024 15:39:03 +0300 [thread overview]
Message-ID: <20240806123906.161218-9-clamor95@gmail.com> (raw)
In-Reply-To: <20240806123906.161218-1-clamor95@gmail.com>
Add mmc nodes configuration along with WIFI binging to ASUS TF701T device-tree.
Signed-off-by: Svyatoslav Ryhel <clamor95@gmail.com>
---
.../boot/dts/nvidia/tegra114-asus-tf701t.dts | 57 ++++++++++++++++++-
1 file changed, 55 insertions(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/nvidia/tegra114-asus-tf701t.dts b/arch/arm/boot/dts/nvidia/tegra114-asus-tf701t.dts
index 9596cb495c10..1fca3e2e5aa1 100644
--- a/arch/arm/boot/dts/nvidia/tegra114-asus-tf701t.dts
+++ b/arch/arm/boot/dts/nvidia/tegra114-asus-tf701t.dts
@@ -1529,8 +1529,53 @@ i2s@70080600 { /* i2s3 */
};
};
+ brcm_wifi_pwrseq: pwrseq-wifi {
+ compatible = "mmc-pwrseq-simple";
+
+ clocks = <&tegra_pmc TEGRA_PMC_CLK_BLINK>;
+ clock-names = "ext_clock";
+
+ reset-gpios = <&gpio TEGRA_GPIO(X, 7) GPIO_ACTIVE_LOW>;
+ post-power-on-delay-ms = <300>;
+ power-off-delay-us = <300>;
+ };
+
+ /* WiFi */
mmc@78000000 {
- /* WiFi */
+ status = "okay";
+
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ assigned-clocks = <&tegra_car TEGRA114_CLK_SDMMC1>;
+ assigned-clock-parents = <&tegra_car TEGRA114_CLK_PLL_P>;
+ assigned-clock-rates = <82000000>;
+
+ max-frequency = <82000000>;
+ keep-power-in-suspend;
+ bus-width = <4>;
+ non-removable;
+
+ sd-uhs-ddr50;
+ mmc-ddr-1_8v;
+
+ power-gpios = <&gpio TEGRA_GPIO(CC, 5) GPIO_ACTIVE_HIGH>;
+
+ nvidia,default-tap = <0x2>;
+ nvidia,default-trim = <0x2>;
+
+ mmc-pwrseq = <&brcm_wifi_pwrseq>;
+ vmmc-supply = <&vdd_3v3_com>;
+ vqmmc-supply = <&vdd_1v8_vio>;
+
+ wifi@1 {
+ compatible = "brcm,bcm4329-fmac";
+ reg = <1>;
+
+ interrupt-parent = <&gpio>;
+ interrupts = <TEGRA_GPIO(U, 5) IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "host-wake";
+ };
};
/* MicroSD card */
@@ -1547,8 +1592,16 @@ mmc@78000400 {
vqmmc-supply = <&vddio_usd>;
};
+ /* eMMC */
mmc@78000600 {
- /* eMMC */
+ status = "okay";
+ bus-width = <8>;
+
+ non-removable;
+ mmc-ddr-1_8v;
+
+ vmmc-supply = <&vcore_emmc>;
+ vqmmc-supply = <&vdd_1v8_vio>;
};
usb@7d000000 {
--
2.43.0
next prev parent reply other threads:[~2024-08-06 12:39 UTC|newest]
Thread overview: 16+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-08-06 12:38 [PATCH v1 00/11] Tegra114: complete TF701T device tree Svyatoslav Ryhel
2024-08-06 12:38 ` [PATCH v1 01/11] ARM: nvidia: tf701t: use unimomentary pinmux setup Svyatoslav Ryhel
2024-08-06 12:38 ` [PATCH v1 02/11] ARM: nvidia: tf701t: bind VDE device Svyatoslav Ryhel
2024-08-06 12:38 ` [PATCH v1 03/11] ARM: nvidia: tf701t: correct and complete PMIC and PMC bindings Svyatoslav Ryhel
2024-08-06 12:38 ` [PATCH v1 04/11] ARM: nvidia: tf701t: add HDMI bindings Svyatoslav Ryhel
2024-08-06 12:39 ` [PATCH v1 05/11] ARM: nvidia: tf701t: add Bluetooth node Svyatoslav Ryhel
2024-08-06 13:33 ` Krzysztof Kozlowski
2024-08-29 15:27 ` Thierry Reding
2024-08-06 12:39 ` [PATCH v1 06/11] ARM: nvidia: tf701t: adjust sensors nodes Svyatoslav Ryhel
2024-08-06 12:39 ` [PATCH v1 07/11] ARM: nvidia: tf701t: complete sound bindings Svyatoslav Ryhel
2024-08-06 12:39 ` Svyatoslav Ryhel [this message]
2024-08-06 12:39 ` [PATCH v1 09/11] ARM: nvidia: tf701t: re-group GPIO keys Svyatoslav Ryhel
2024-08-06 12:39 ` [PATCH v1 10/11] ARM: nvidia: tf701t: use dedicated backlight regulator Svyatoslav Ryhel
2024-08-06 12:39 ` [PATCH v1 11/11] ARM: nvidia: tf701t: configure USB Svyatoslav Ryhel
2024-08-06 13:43 ` [PATCH v1 00/11] Tegra114: complete TF701T device tree Rob Herring (Arm)
2024-08-29 15:26 ` Thierry Reding
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20240806123906.161218-9-clamor95@gmail.com \
--to=clamor95@gmail.com \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=jonathanh@nvidia.com \
--cc=krzysztof.kozlowski+dt@linaro.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-tegra@vger.kernel.org \
--cc=robh+dt@kernel.org \
--cc=thierry.reding@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®