[PATCH] spi: cadence-quadspi: Enable SPI_TX_QUAD

[Santhosh Kumar K <s-k6@ti.com>]

Enable the SPI_TX_QUAD mode bit in the host->mode_bits to support
data transmission over four lines to improve the performance.

Tested the functionality on AM62Lx EVM (W25N01JW) in 1S-4S-4S mode.

Signed-off-by: Santhosh Kumar K <s-k6@ti.com>
---

Repo: https://github.com/santhosh21/linux/tree/uL_next
Test results: https://gist.github.com/santhosh21/71ab6646dccc238a0b3c47c0382f219a

Regards,
Santhosh.

 drivers/spi/spi-cadence-quadspi.c | 5 ++++-
 1 file changed, 4 insertions(+), 1 deletion(-)

diff --git a/drivers/spi/spi-cadence-quadspi.c b/drivers/spi/spi-cadence-quadspi.c
index 47477f2d9a25..594408d53400 100644
--- a/drivers/spi/spi-cadence-quadspi.c
+++ b/drivers/spi/spi-cadence-quadspi.c
@@ -49,6 +49,7 @@ static_assert(CQSPI_MAX_CHIPSELECT <= SPI_CS_CNT_MAX);
 
 /* Capabilities */
 #define CQSPI_SUPPORTS_OCTAL		BIT(0)
+#define CQSPI_SUPPORTS_QUAD		BIT(1)
 
 #define CQSPI_OP_WIDTH(part) ((part).nbytes ? ilog2((part).buswidth) : 0)
 
@@ -1888,6 +1889,8 @@ static int cqspi_probe(struct platform_device *pdev)
 						cqspi->master_ref_clk_hz);
 		if (ddata->hwcaps_mask & CQSPI_SUPPORTS_OCTAL)
 			host->mode_bits |= SPI_RX_OCTAL | SPI_TX_OCTAL;
+		if (ddata->hwcaps_mask & CQSPI_SUPPORTS_QUAD)
+			host->mode_bits |= SPI_TX_QUAD;
 		if (!(ddata->quirks & CQSPI_DISABLE_DAC_MODE)) {
 			cqspi->use_direct_mode = true;
 			cqspi->use_direct_mode_wr = true;
@@ -2062,7 +2065,7 @@ static const struct cqspi_driver_platdata k2g_qspi = {
 };
 
 static const struct cqspi_driver_platdata am654_ospi = {
-	.hwcaps_mask = CQSPI_SUPPORTS_OCTAL,
+	.hwcaps_mask = CQSPI_SUPPORTS_OCTAL | CQSPI_SUPPORTS_QUAD,
 	.quirks = CQSPI_NEEDS_WR_DELAY,
 };
 
-- 
2.34.1