[PATCH v6 03/14] phy: rockchip: samsung-hdptx: Fix clock ratio setup

[Cristian Ciocaltea <cristian.ciocaltea@collabora.com>]

The switch from 1/10 to 1/40 clock ratio must happen when exceeding the
340 MHz rate limit of HDMI 1.4, i.e. when entering the HDMI 2.0 domain,
and not before.

Therefore, use the correct comparison operator '>' instead of '>=' when
checking the max rate.  While at it, introduce a define for this rate
limit constant.

Fixes: 553be2830c5f ("phy: rockchip: Add Samsung HDMI/eDP Combo PHY driver")
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea@collabora.com>
---
 drivers/phy/rockchip/phy-rockchip-samsung-hdptx.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/phy/rockchip/phy-rockchip-samsung-hdptx.c b/drivers/phy/rockchip/phy-rockchip-samsung-hdptx.c
index fe7c057483563686b8076cf2ce562440cfa6fe55..34a7ef20936422b540b699f1acba44ca465501b7 100644
--- a/drivers/phy/rockchip/phy-rockchip-samsung-hdptx.c
+++ b/drivers/phy/rockchip/phy-rockchip-samsung-hdptx.c
@@ -320,6 +320,7 @@
 #define LN3_TX_SER_RATE_SEL_HBR2_MASK	BIT(3)
 #define LN3_TX_SER_RATE_SEL_HBR3_MASK	BIT(2)
 
+#define HDMI14_MAX_RATE			340000000
 #define HDMI20_MAX_RATE			600000000
 
 enum dp_link_rate {
@@ -1072,7 +1073,7 @@ static int rk_hdptx_ropll_tmds_mode_config(struct rk_hdptx_phy *hdptx,
 
 	regmap_write(hdptx->regmap, LNTOP_REG(0200), 0x06);
 
-	if (rate >= 3400000) {
+	if (rate > HDMI14_MAX_RATE / 100) {
 		/* For 1/40 bitrate clk */
 		rk_hdptx_multi_reg_write(hdptx, rk_hdtpx_tmds_lntop_highbr_seq);
 	} else {

-- 
2.48.1