[PATCH v2 1/1] x86/fred: Fix system hang during S4 resume with FRED enabled

["Xin Li (Intel)" <xin@zytor.com>]

Upon a wakeup from S4, the restore kernel starts and initializes the
FRED MSRs as needed from its perspective.  It then loads a hibernation
image, including the image kernel, and attempts to load image pages
directly into their original page frames used before hibernation unless
those frames are currently in use.  Once all pages are moved to their
original locations, it jumps to a "trampoline" page in the image kernel.

At this point, the image kernel takes control, but the FRED MSRs still
contain values set by the restore kernel, which may differ from those
set by the image kernel before hibernation.  Therefore, the image kernel
must ensure the FRED MSRs have the same values as before hibernation.
Since these values depend only on the location of the kernel text and
data, they can be recomputed from scratch.

Reported-by: Xi Pardee <xi.pardee@intel.com>
Reported-by: Todd Brandt <todd.e.brandt@intel.com>
Suggested-by: H. Peter Anvin (Intel) <hpa@zytor.com>
Signed-off-by: Xin Li (Intel) <xin@zytor.com>
Tested-by: Todd Brandt <todd.e.brandt@intel.com>
Cc: Andy Lutomirski <luto@kernel.org>
Cc: Brian Gerst <brgerst@gmail.com>
Cc: Juergen Gross <jgross@suse.com>
Cc: Linus Torvalds <torvalds@linux-foundation.org>
Cc: stable@vger.kernel.org # 6.9+
---

Change in v2:
* Rewrite the change log and in-code comments based on Rafael's feedback.
---
 arch/x86/power/cpu.c | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

diff --git a/arch/x86/power/cpu.c b/arch/x86/power/cpu.c
index 63230ff8cf4f..08e76a5ca155 100644
--- a/arch/x86/power/cpu.c
+++ b/arch/x86/power/cpu.c
@@ -27,6 +27,7 @@
 #include <asm/mmu_context.h>
 #include <asm/cpu_device_id.h>
 #include <asm/microcode.h>
+#include <asm/fred.h>
 
 #ifdef CONFIG_X86_32
 __visible unsigned long saved_context_ebx;
@@ -231,6 +232,19 @@ static void notrace __restore_processor_state(struct saved_context *ctxt)
 	 */
 #ifdef CONFIG_X86_64
 	wrmsrl(MSR_GS_BASE, ctxt->kernelmode_gs_base);
+
+	/*
+	 * Reinitialize FRED to ensure the FRED MSRs contain the same values
+	 * as before hibernation.
+	 *
+	 * Note, the setup of FRED RSPs requires access to percpu data
+	 * structures.  Therefore, FRED reinitialization can only occur after
+	 * the percpu access pointer (i.e., MSR_GS_BASE) is restored.
+	 */
+	if (ctxt->cr4 & X86_CR4_FRED) {
+		cpu_init_fred_exceptions();
+		cpu_init_fred_rsps();
+	}
 #else
 	loadsegment(fs, __KERNEL_PERCPU);
 #endif

base-commit: 535bd326c5657fe570f41b1f76941e449d9e2062
-- 
2.49.0