[PATCH v1 2/2] gpiolib: of: Move Atmel HSMCI quirk up out of the regulator comment

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

The regulator comment in of_gpio_set_polarity_by_property()
made on top of a couple of the cases, while Atmel HSMCI quirk
is not related to that. Make it clear by moving Atmel HSMCI
quirk up out of the scope of the regulator comment.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
---
 drivers/gpio/gpiolib-of.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/gpio/gpiolib-of.c b/drivers/gpio/gpiolib-of.c
index 8fff6fdfb4a1..65f6a7177b78 100644
--- a/drivers/gpio/gpiolib-of.c
+++ b/drivers/gpio/gpiolib-of.c
@@ -268,6 +268,9 @@ static void of_gpio_set_polarity_by_property(const struct device_node *np,
 		{ "fsl,imx8qm-fec",  "phy-reset-gpios", "phy-reset-active-high" },
 		{ "fsl,s32v234-fec", "phy-reset-gpios", "phy-reset-active-high" },
 #endif
+#if IS_ENABLED(CONFIG_MMC_ATMELMCI)
+		{ "atmel,hsmci",       "cd-gpios",     "cd-inverted" },
+#endif
 #if IS_ENABLED(CONFIG_PCI_IMX6)
 		{ "fsl,imx6q-pcie",  "reset-gpio", "reset-gpio-active-high" },
 		{ "fsl,imx6sx-pcie", "reset-gpio", "reset-gpio-active-high" },
@@ -293,9 +296,6 @@ static void of_gpio_set_polarity_by_property(const struct device_node *np,
 #if IS_ENABLED(CONFIG_REGULATOR_GPIO)
 		{ "regulator-gpio",    "enable-gpio",  "enable-active-high" },
 		{ "regulator-gpio",    "enable-gpios", "enable-active-high" },
-#endif
-#if IS_ENABLED(CONFIG_MMC_ATMELMCI)
-		{ "atmel,hsmci",       "cd-gpios",     "cd-inverted" },
 #endif
 	};
 	unsigned int i;
-- 
2.47.2