[PATCH] bus: mhi: host: fix endianness of BHI vector table

[Alexander Wilhelm <alexander.wilhelm@westermo.com>]

On big endian platforms like PowerPC the DMA address and size are required
to be swapped. Otherwise the MHI bus does not start properly. The following
example shows the error messages by using qcn9274 wireless radio module
with ath12k driver:

    ath12k_pci 0001:01:00.0: BAR 0: assigned [mem 0xc00000000-0xc001fffff 64bit]
    ath12k_pci 0001:01:00.0: MSI vectors: 1
    ath12k_pci 0001:01:00.0: Hardware name: qcn9274 hw2.0
    ath12k_pci 0001:01:00.0: failed to set mhi state: POWER_ON(2)
    ath12k_pci 0001:01:00.0: failed to start mhi: -110
    ath12k_pci 0001:01:00.0: failed to power up :-110
    ath12k_pci 0001:01:00.0: failed to create soc core: -110
    ath12k_pci 0001:01:00.0: failed to init core: -110
    ath12k_pci: probe of 0001:01:00.0 failed with error -110

Signed-off-by: Alexander Wilhelm <alexander.wilhelm@westermo.com>
---
 drivers/bus/mhi/host/boot.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/bus/mhi/host/boot.c b/drivers/bus/mhi/host/boot.c
index efa3b6dddf4d..205d83ac069f 100644
--- a/drivers/bus/mhi/host/boot.c
+++ b/drivers/bus/mhi/host/boot.c
@@ -31,8 +31,8 @@ int mhi_rddm_prepare(struct mhi_controller *mhi_cntrl,
 	int ret;
 
 	for (i = 0; i < img_info->entries - 1; i++, mhi_buf++, bhi_vec++) {
-		bhi_vec->dma_addr = mhi_buf->dma_addr;
-		bhi_vec->size = mhi_buf->len;
+		bhi_vec->dma_addr = cpu_to_le64(mhi_buf->dma_addr);
+		bhi_vec->size = cpu_to_le64(mhi_buf->len);
 	}
 
 	dev_dbg(dev, "BHIe programming for RDDM\n");
@@ -431,8 +431,8 @@ static void mhi_firmware_copy_bhie(struct mhi_controller *mhi_cntrl,
 	while (remainder) {
 		to_cpy = min(remainder, mhi_buf->len);
 		memcpy(mhi_buf->buf, buf, to_cpy);
-		bhi_vec->dma_addr = mhi_buf->dma_addr;
-		bhi_vec->size = to_cpy;
+		bhi_vec->dma_addr = cpu_to_le64(mhi_buf->dma_addr);
+		bhi_vec->size = cpu_to_le64(to_cpy);
 
 		buf += to_cpy;
 		remainder -= to_cpy;
-- 
2.34.1